Abstract:alpha-Fe2O3 has been widely reported as negative electrodes in aqueous based energy storage systems. Yet, investigation on its electrochemical behavior and energy storage mechanism is still a desolate field, especially as anodes for batteries. Herein, ring-like alpha-Fe2O3 is synthesized and its charge storage behavior is explored in both neutral and alkaline electrolytes. The as-obtained samples exhibit high capacities with low negative charging/discharging plateaus but poor cycling performance. In Li2SO4, a reversible capacity of 90 mAh g(-1) at 1 A g(-1) is achieved, while it declines quickly to about zero at the first 20 cycles. In Na2SO4 and K2SO4 with larger cations, the initial capacities are lower and the decay speeds are faster, indicating a cation involved charge storage process. With careful analysis, it is proposed that part of Fe2O3 is reduced to be resoluble Fe2+ followed by the formation of Fe(OH)(2) around the electrode in low potential range owning to the insertion of (H3O)(+), and subsequently converted into FeOOH as precipitation, which would cause irreversible mass loss and hence fast capacity decay. While in alkaline solution of LiOH, a higher reversible capacity of similar to 160 mAh g(-1) at 1 A g(-1) is reached accompanied by better cycling performance and much higher Coulombic efficiency of similar to 100%. Yet, the durability is still unsatisfied. With operando Raman, it is found that Fe2O3 is irreversibly reduced to be Fe3O4 during the discharging process. Structural collapse of Fe3O4 during the following cycles should take main responsibility for the poor durability. Hence, how to inhibit mass loss of Fe2O3 in neutral solution and structure collapse of Fe3O4 in alkaline solution is supposed to be effective strategy to enhance the stability of Fe2O3 based electrodes. (C) 2020 Elsevier B.V. All rights reserved.

Mechanism of Electrochemical Hydrogen Storage for Α-Fe2o3particles As Anode Material for Aqueous Rechargeable Batteries

Fe2O3–Ag Porous Film Anodes for Ultrahigh‐Rate Lithium‐Ion Batteries

Superlattice Formation of Crystal Water in Layered Double Hydroxides for Long‐Term and Fast Operation of Aqueous Rechargeable Batteries

Charge Storage Behavior and Reaction Mechanism of Α-Fe2o3 As Anodes for Aqueous Batteries

Electrochemical Performance Of Alpha-Fe2o3 Particles As Anode Material For Aqueous Rechargeable Batteries

Microstructure Design of Electrolytes for High-Energy-Density Aqueous Batteries

Hydrogen bond chemistry in Fe4[Fe(CN)6]3 host for aqueous NH4+ batteries

Synthesis And Lithium Storage Performance Of Alpha-Fe2o3-Ag Hybrid Nanorod Anode For Lithium-Ion Batteries

Exploring Fe Redox Enabled by Kinetically Stabilized Interphase for Rechargeable Aluminum Batteries

In Situ Induced Interface Engineering in Hierarchical Fe3O4 Enhances Performance for Alkaline Solid-State Energy Storage

Boosting the Energy Density of Aqueous Batteries via Facile Grotthuss Proton Transport

Aqueous Electrolytes Reinforced by Mg and Ca Ions for Highly Reversible Fe Metal Batteries

Anhydrous Fast Proton Transport Boosted by the Hydrogen Bond Network in a Dense Oxide-Ion Array of α-MoO3

Aqueous Dual‐Ion Battery Based on a Hematite Anode with Exposed {1 0 4} Facets

Aqueous Dual-Ion Battery Based on Hematite Anode with Exposed {104} Facets.

Elevating the gravimetric energy density of Fe 2+ rocking-chair batteries by 2600 % with unique anode/cathode-free configuration and efficient electrolyte engineering

Fe 2+ /fe 3+ Cycling for Coupling Self‐Powered Hydrogen Evolution and Preparation of Electrode Catalysts

Oxygen Vacancies Boosted Hydronium Intercalation: A Paradigm Shift in Aluminum‐based Batteries

Li2ZnTi3O8@α-Fe2O3 Composite Anode Material for Li-ion Batteries

Investigating intercalation mechanism of manganese oxide electrode in aqueous aluminum electrolyte

Li‐Ion Batteries: SnO2 Anode Surface Passivation by Atomic Layer Deposited HfO2 Improves Li‐Ion Battery Performance (Small 14/2014)