Abstract:The dependences of the structural, mechanical, electronic and optical properties of Al3Sc intermetallic compound on pressure were studied using the first-principles method based on the density functional theory with generalized gradient approximation and local density approximation methods. The results showed the pressure has the significant impact on the equilibrium volume, mechanical properties, electronic properties and optical properties of Al3Sc. The calculated structural and mechanical parameters (i.e., bulk modulus (B), shear modulus (G), Young's modulus (E), Poisson's ratio (v), and Debye temperature (0(D))) were in good agreement both with the previously reported experimental and theoretical results at zero pressure. Additionally, all these parameters presented the linearly increasing dependences on the external pressure. The B/G ratios indicated the Al3Sc crystals should exhibit brittle deformation behavior at 0-50 GPa. The universal anisotropic index (A(U)) signified the Al3Sc compound was near elastically isotropic under zero pressure, and may become anisotropic as the pressure increased. Further, the pressure-dependent behaviors of density of states (DOS), Mulliken charge and bond length were discussed. In the DOS spectra, the values of D-Total(Al3Sc), D-p(Al) and D-d(Sc) were all reduced as the pressure was elevated at the Fermi level. However, the relative contributions to the D-Total(Al3Sc) from Alp state were found slightly increased, and Sc3d state remained leveled. Finally, the optical conductivity spectra were simulated as a function of the external pressure. The two peak positions in such spectra were successfully identified and compared with other reported values. (C) 2014 Elsevier B.V. All rights reserved.

The Effect of Alloying Elements on the Structural Stability, and Mechanical and Electronic Properties of Al 3 Sc: A First-Principles Study.

Effects of Sc on the Vacancy and Solute Behaviours in Aluminium

The Effect Of Alloying Elements On The Structural Stability, Mechanical Properties, And Debye Temperature Of Al3li: A First-Principles Study

FIRST-PRINCIPLES INVESTIGATION OF THE THERMODYNAMICS PROPERTIES OF Al3Sc AND Al3Zr INTERMETALLICS

Effect of Zr, Hf, and Sn Additives on Elastic Properties of Α2-Ti3al Phase by First-Principles Calculations

The Structural Stability and Mechanical Properties of Doped Al2Cu Precipitates with Different Elements by First-Principles Calculations

Ab initio study of the effect of Zr content on elastic and electronic properties of L12–Al3(Sc1−xZrx) alloys

Mechanical and thermodynamic properties of Al3Sc and Al3Li precipitates in Al–Li–Sc alloys from first-principles calculations

EFFECT OF Sc ON MICROSTRUCTURE AND PROPERTIES OF Al-Li-Cu-Mg-Zr ALLOY

Elastic properties of random L1 2-Al 3(Sc 0.5TM 0.5) alloys from first-principle SQSs calculations

Thermodynamic, elastic and electronic properties of AlSc 2 Si 2

First-principles study on alloying stability, electronic structure, and mechanical properties of Al-based intermetallics

The Effect of Sc Addition on Microstructure and Mechanical Properties of As-Cast Zr-containing Al-Cu Alloys

The Structural Stability and Mechanical Properties of Doped Al2Cu 2 Cu Precipitates with Different Elements by First-Principles Calculations

Elastic properties of random L1 2 –Al 3 (Sc 0.5 TM 0.5 ) alloys from first-principle SQSs calculations

Calculation of point defect structures and bonding behavior of L12-Al3Sc intermetallic based on first-principles

Effects of Sc Addition on the Microstructure and Mechanical Properties of Cast Al-3Li-1.5Cu-0.15Zr Alloy

Calculation of point defect structures and bonding behavior of L1 2-Al 3 Sc intermetallic based on first-principles

First-principles Calculation of Various Phase Transition in Al–Sc System

Finite-temperature ductility-brittleness and electronic structures of Al$_{n}$Sc (n=1, 2 and 3)

First-principles investigation of mechanical, electronic and optical properties of Al 3 Sc intermetallic compound under pressure