Abstract:The nano/microstructuring of silicon (Si) via chemical methods has garnered significant attention due to its excellent light-trapping capabilities across a wide spectral range. Current research has predominantly focused on the synthesis of pyramidal-shaped microtextures, which enable two reflections on the surface, while largely overlooking the superior light-trapping potential of inverted pyramid silicon (SiIP) microtextures, which theoretically allow for three reflections. Moreover, there has been limited investigation into the application of inverted pyramid black silicon for solar-driven hydrogen evolution. This study reports the synthesis of uniformly arranged inverted pyramid-textured black silicon using the copper-assisted chemical etching (Cu-ACE) method to enhance the efficiency of solar-driven water splitting for hydrogen production. The formation mechanism and the influence of copper-localized surface plasmon resonance (Cu-LSPR) from Cu nanoparticle (NP) byproducts on photoelectrochemical (PEC) activity were systematically analyzed. To reduce sidewall defects and minimize photogenerated carrier recombination, the surface of the SiIP was treated with tetramethylammonium hydroxide (TMAH). A vertical PN junction was developed through ion implantation to reduce the external bias of the SiIP. Additionally, a uniform TiO2 antireflective layer was deposited via atomic layer deposition (ALD), reducing the average reflectance of the SiIP-T-4 to 5.78 % over the 300-1100 nm wavelength range. MoSx and Pt NPs were electrodeposited to improve the fill factor and enhance HER kinetics. With optimized catalyst loading, the n(+)p-SiIP-T-4/TiO2/Pt 80 mC electrode achieved a photocurrent density of 8.0 mA cm(-2) at 0 V vs. RHE, an applied bias photon-to-current efficiency (ABPE) of 0.93 % at 0.24 V vs. RHE, and a double-layer capacitance (Cdl) of 91 mu F cm(-2). The onset potential (Von) was positively shifted by similar to 1.13 V to 0.49 V vs. RHE compared to a SiIP photocathode, and the photocathode operated continuously at 0 V vs. RHE for 27 h in an acidic electrolyte. These results demonstrate that SiIP has significant potential for PEC hydrogen evolution, with further performance optimization achievable through structural and surface engineering.

Enhancing the Performance of Si-Based Photocathodes for Solar Hydrogen Production in Alkaline Solution by Facilely Intercalating a Sandwich N-Doped Carbon Nanolayer to the Interface of Si and TiO2.

Interface-engineered silicon photocathodes with a NiCoP catalyst-modified TiO2 nanorod array outlayer for photoelectrochemical hydrogen production in alkaline solution

(Invited) Si/NiCoSex Nanorods Photocathode for Enhanced Photoelectrochemical Hydrogen Production

High Performance P-Si/ni3s2 Photocathode for Photoelectrochemical Hydrogen Evolution in Neutral Solution

Highly Efficient and Stable Si Photocathode with Hierarchical MoS2/Ni3S2 Catalyst for Solar Hydrogen Production in Alkaline Media

High Performance N + P-Si/ti/nis X O Y Photocathode for Photoelectrochemical Hydrogen Evolution in Alkaline Solution

Efficient Photoelectrochemical Hydrogen Evolution on Silicon Photocathodes Interfaced with Nanostructured NiP2 Cocatalyst Films.

Surface Engineering of Nanoporous Silicon Photocathodes for Enhanced Photoelectrochemical Hydrogen Production

Ti/Co-S catalyst covered amorphous Si-based photocathodes with high photovoltage for the HER in non-acid environments

Nanoporous Silicon Photocathodes with [Co] Molecular Catalyst for Enhanced Solar-Driven Hydrogen Generation

Gradient‐Structuring Manipulation in Ni 3 S 2 Layer Boosts Solar Hydrogen Production of Si Photocathode in Alkaline Media

Gradient‐Structuring Manipulation in Ni3S2 Layer Boosts Solar Hydrogen Production of Si Photocathode in Alkaline Media

Dissolution-Induced Surface Reconstruction of Ni0.95Pt0.05Si/p-Si Photocathode for Efficient Photoelectrochemical H2 Production

Nickel-coated Silicon Photocathode for Water Splitting in Alkaline Electrolytes

A Thin-Film Silicon Based Photocathode With A Hydrogen Doped Tio2 Protection Layer For Solar Hydrogen Evolution

Enhancing Photoelectrochemical Hydrogen Production Of A N(+)P-Si Hetero-Junction Photocathode With Amorphous Ni And Ti Layers

Boosting Unassisted Alkaline Solar Water Splitting Using Silicon Photocathode with TiO 2 Nanorods Decorated by Edge‐Rich MoS 2 Nanoplates

Inverted Pyramid Textured P-Silicon Covered with Co2P As an Efficient and Stable Solar Hydrogen Evolution Photocathode

Solution‐Processed Fabrication of Ni3S2‐Based Nanoheterostructure on Silicon Heterojunction Photocathode for Boosting Solar Hydrogen Generation

Enhanced Solar Hydrogen Evolution by Laminated Integration of N+P-Siip/Tio2/Pt Inverted Pyramid Black Si Photocathode

Co Nanoparticles@N-doped Carbon Coated on Carbon Nanotube@Defective Silica As Non-Noble Photocathode for Efficient Photoelectrochemical Hydrogen Generation