Abstract:Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, Ahead of Print. Nowadays, many studies concerning plasticity and numerical simulations indicate that the true stress–strain curve plays a prominent role in the analysis of metal deformation. Hence, a new method is considered to correct the stress–strain curve based on image processing. Since the axial stress mainly becomes triaxial in the neck zone, the relationship obtained from the engineering stress–strain curve is not reliable in terms of authenticity and accuracy. Accordingly, correcting this relationship is highly advantageous and necessary. Due to the triaxial state of stress in the plastic area, longitudinal and surface strains are calculated through image processing and the correction coefficient of the stress–strain curve is obtained based on them. The equation of the stress–strain curve is based on the Hollowman relation until the onset of necking and then becomes almost linear. The finite element method (FEM) is employed for validating the obtained results. Since the corrected stress and strain equation is linear, the objective function of optimization is considered. This optimization is based on minimizing the difference between the three diameters values of the specimen, which are observed through experiment and FEM. Besides, a statistical method with the help of the genetic algorithm is employed to minimize this difference. As a result, an optimal equation is predicted for the 2024 aluminum based on the stress–strain curve of the error rate. Finally, a comparison is made between the results obtained from the surface strain method and the results obtained from the classical methods of Bridgman and Davidenkov, and a good agreement is observed between them.

A Correction to the Stress–Strain Curve During Multistage Hot Deformation of 7150 Aluminum Alloy Using Instantaneous Friction Factors

Correction and Modeling of Flow Stress during Hot Deformation of 7055 Aluminum Alloy

Correction of the stress–strain curve for 2024 aluminum alloy after necking using the new surface strain method

Correction of flow stress data due to non-homogeneous deformation and thermal conditions during hot compression testing of a polycrystalline nickel-base superalloy

Friction correction of flow stress-strain curve in the upsetting process

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Prediction of Flow Stress and Characterizing the Deformation Mechanism of As‐extruded 7005 Aluminum Alloy

A Forward Identification Method for High-Temperature Stress-Strain Curves of 7075 Aluminum Alloy Sheet Considering the Necking Stage

Data correction and verification of thermal simulation experiments under the influence of bulging belly

Constitutive Equation for 3104 Alloy at High Temperatures in Consideration of Strain

Constitutive behavior and novel characterization of hot deformation of Al-Zn-Mg-Cu aluminum alloy for lightweight traffic

Constitutive Modeling of the Hot Deformation Behavior in 6082 Aluminum Alloy

Experimental and Physical-Based Constitutive Model Study of Fcc Metal over Wide Temperature and Strain Rate Ranges

A Physically Based Constitutive Model and Continuous Dynamic Recrystallization Behavior Analysis of 2219 Aluminum Alloy during Hot Deformation Process

Study of Hot Deformation Behavior of 6082 Aluminum Alloy

Accurate Flow Characterization of A6082 for Precision Simulation of a Hot Metal Forming Process

Research on the relationship of FDI and rural economy growth in the Northeast area

Flow behavior and dynamic recrystallization mechanism of A5083 aluminum alloys with different initial microstructures during hot compression

Large strain flow curve identification for sheet metals under complex stress states

Constitutive model for hot deformation of aluminum alloy

An Enhanced Johnson–Cook Model for Hot Compressed A356 Aluminum Alloy