Abstract:Aeolian sandy soil in mining areas exhibits intense evaporation and poor water retention capacity. This study was designed to find a suitable biochar application method to improve soil water infiltration and minimize soil water evaporation for aeolian sand soil. Using the indoor soil column method, we studied the effects of three application patterns (A (0–20 cm was a mixed sample of mixed-based biochar and soil), B (0–10 cm was a mixed sample of mixed-based biochar and soil and 10–20 cm was soil), and C (0–10 cm was soil and 10–20 cm was a mixed sample of mixed-based biochar and soil)), four application amounts (0% (control, CK), 1%, 2%, and 4% of mixed-based biochar in dry soil), and two particle sizes (0.05–0.25 mm (S1) and <0.05 mm (S2)) of mixed-based biochar on water infiltration and evaporation of aeolian sandy soil. We separately used five infiltration models (the Philip, Kostiakov, Horton, USDA-NRCS (United States Department of Agriculture-Natural Resources Conservation Service), and Kostiakov-Lewis models) to fit cumulative infiltration and time. Compared with CK, the application of mixed-based biochar significantly reduced cumulative soil water infiltration. Under application patterns A, B, and C, the higher the application amount and the finer the particle size were, the lower the migration speed of the wetting front. With the same application amount, cumulative soil water infiltration under application pattern A was the lowest. Taking infiltration for 10 min as an example, the reductions of cumulative soil water infiltration under the treatments of A2% (S2) , A4% (S1) , A4% (S2) , A1% (S1) , C2% (S1) , and B1% (S1) were higher than 30%, which met the requirements of loess soil hydraulic parameters suitable for plant growth. The five infiltration models well fitted the effects of the treatments of application pattern C and S1 particle size ( R 2 >0.980), but the R 2 values of the Horton model exceeded 0.990 for all treatments (except for the treatment B2% (S2) ). Compared with CK, all other treatments reduced cumulative soil water infiltration, except for B4% (S2) . With the same application amount, cumulative soil water evaporation difference between application patterns A and B was small. Treatments of application pattern C and S1 particle size caused a larger reduction in cumulative soil water evaporation. The reductions in cumulative soil water evaporation under the treatments of C4% (S1) , C4% (S2) , C2% (S1) , and C2% (S2) were over 15.00%. Therefore, applying 2% of mixed-based biochar with S1 particle size to the underlying layer (10–20 cm) could improve soil water infiltration while minimizing soil water evaporation. Moreover, application pattern was the main factor affecting soil water infiltration and evaporation. Further, there were interactions among the three influencing factors in the infiltration process (application amount×particle size with the most important interaction), while there were no interactions among them in the evaporation process. The results of this study could contribute to the rational application of mixed-based biochar in aeolian sandy soil and the resource utilization of urban and agricultural wastes in mining areas.

Optimal ratios and particle sizes for simulating natural soil water retention in reconstructed soil using mining strips

Evaluating The Water Holding Capacity Of Multilayer Soil Profiles Using Hydrus-1d And Multi-Criteria Decision Analysis

Optimization of Concurrent Mining and Reclamation Plans for Single Coal Seam: a Case Study in Northern Anhui, China

Analysis of differences in chemical properties of reconstructed soil under different proportions of topsoil substitute materials

Water Retention Behavior and Shear Strength of Artificially Cemented Granite Residual Soil Subjected to Free Drying

Impacts of re-vegetation on soil water dynamics in a semiarid region of Northwest China

Variability of soil water and effect of soil reconstruction in Xilin Hot steppe mining area

Soil Reclamation Models by Soil Water Infiltration for Refuse Dumps in Opencast Mining Area of Northern China

Evaluating the soil evaporation loss rate in a gravel-sand mulching environment based on stable isotopes data

Optimal mixing ratio and SWCC fitting of lightweight soil with cotton stalk fibres

Effects of mixed-based biochar on water infiltration and evaporation in aeolian sand soil

A new small-scale system of rainwater harvesting combined with irrigation for afforestation in mine area: Optimizing design and application

Soil Aggregates and Water Infiltration Performance of Different Water and Soil Conservation Measures on Phaeozems Sloping Farmland in Northeast China

Multispectral Remote Sensing Monitoring of Soil Particle-Size Distribution in Arid and Semi-Arid Mining Areas in the Middle and Upper Reaches of the Yellow River Basin: A Case Study of Wuhai City, Inner Mongolia Autonomous Region

Soil moisture evidence of self-restoration in coal mining subsidence area of Shendong Mining area: Cognition based on stable isotopes

Combination of artificial zeolite and microbial fertilizer to improve mining soils in an arid area of Inner Mongolia, China

Mixture-proportioning design of cement soil containing Pisha sandstone for mine filling

Physicochemical Properties and Planting Performance of Artificial Soil Developed from Multiple Coal-Based Solid Waste Materials

A New Idea to Improve the Test Method of Soil Aggregate Stability for Soils with a Texture Gradient

Optimization of Reclamation Measures in a Mining Area by Analysis of Variations in Soil Nutrient Grades under Different Types of Land Usage—A Case Study of Pingshuo Coal Mine, China

Modelling soil-water retention curves subject to multiple wetting-drying cycles: An approach for expansive soils