Effect of Zirconium on Microstructures and Mechanical Properties of Squeeze Cast Al–5.0Cu–0.4Mn–0.1Ti–0.1RE Alloy

Fan-sheng Meng,Wei-wen Zhang,Yuan Hu,Da-tong Zhang,Chao Yang

DOI: https://doi.org/10.1007/s11771-017-3632-4

2017-01-01

Journal of Central South University

Abstract:Al–5.0Cu–0.4Mn alloys with different Zr additions have been prepared by direct squeeze casting. The effects of Zr on microstructures and mechanical properties of the as-cast and T6 heat-treated alloys were investigated by tensile test, optical microscope (OM), scanning electron microscope (SEM) and transmission electron microscope (TEM). The results show that the optimal tensile property of the as-cast alloy occurs at the Zr content of 0.15% (mass fraction) due to the “Zr poisoning” action and the appearance of bulky primary Al3Zr, which decreases the grain refinement strengthening effect of the as-cast alloy. The peak values of ultimate tensile strength and yield strength of the T6 alloy occur at the Zr content of 0.25%, and that of the elongation occurs at Zr content of 0.05%. This is mainly attributed to the strengthening effect of dispersed precipitation of Al3Zr and θ’ phases. The optimal mechanical properties of T6 heat-treated alloy are the tensile strength of 429 MPa, the yield strength of 327 MPa and the elongation of 18%, respectively when the squeeze pressure is 100 MPa and Zr content is 0.25%.