Abstract:Present semiconductor research is increasingly focusing on either higher speeds or higher linearity or both. Applications range from consumer, industrial, healthcare and military. Typically such circuits are fabricated in today's low-voltage CMOS processes using silicon and in few cases BJT-CMOS combined like Gallium-Arsenide or Indium-Phosphide. These technology nodes face a plethora of problems like reduction of dynamic range of the circuit due to mismatch, distortion, noise, thermal and electromigration issues due to excessive currents, etc. Compounding these problems is the issue with lower achievable gain from an amplifier which often gets limited due to lower supply voltages in such technology nodes. Slowly circuit techniques like chopping, cascoding, cascading and calibration are nearing their limits. In this paper we present a radically different approach to our regular analog design building blocks using macroscopic quantum effects which have hitherto not found favour with the design community. We will solely focus on the effect of superconductivity and adopting its macroscopic phenomena to amplifiers, integrators and comparators. Using staggered superconductors we can achieve a gain which depends only on physical quantum constants and remains invariant under process, temperature, supply, interference, etc. This robustness of gain in an amplifier goes a long way in attaining higher linearity. The comparator can resolve a minimum of 2.07fT magnetic flux but when embedded inside a Delta-Sigma loop can typically attain 100 times smaller resolution pushing the boundaries of sensing.

Accurate Measurement of Gain Saturation of Superconductor–Insulator–Superconductor Mixers with Logarithmic Power Detectors

Inconstant Output Noise of SIS Mixers and Its Implication in Input Noise Measurement

Experiments and Comparisons of Power to Failure for SiGe-Based Low-Noise Amplifiers under High-Power Microwave Pulses

Measurement of the direct-detection responses of a 500-GHz and a 660-GHz waveguide superconducting SIS mixer

Engineering physics of superconducting hot-electron bolometer mixers

Nondestructive Measurement and High-Precision Evaluation of the Electrical Conductivity of Doped GaAs Wafers Using Microwaves.

Operation of Mixer Comprising a Series-Connected Distributed Superconductor–Insulator–Superconductor Junction Array

An Anomalous Peak on Intermediate Frequency Response of Superconductor-Isolator-Superconductor Mixers and Its Effect on Mixing Performance

Direct Measurement of the Input RF Noise of Superconducting Hot Electron Bolometer Receivers

Superconducting Quantum Amplifier-Integrator in Ultra-High Speed Continuous-time Delta-Sigma Converter

Noise Performance of a 200–280 GHz Mixer with Nb-AlN-NbN Superconducting Tunnel Junctions

THE DESIGN OF SUPERCONDUCTOR MIXER AT 500Ghz

Direct-detection Characteristics of an 850-Ghz Niobium-based Superconducting SIS Mixer

Observation of Frequency Up-Conversion Gain in SIS Junctions at W Band

Gain Stability Analysis of A Millimeter Wave Superconducting Heterodyne Receiver for Radio Astronomy

Temperature-dependent Performances of Nb SIS Mixers at Millimeter and Submillimeter Wavelength Microwave and Millimeter Wave Technology

Analysis Of Rf-Noise Contribution In Thz Superconducting Sis Mixers

Noise figure measurement within high temperature superconductor mixer

Temperature-dependent Performances of Nb SIS Mixers at Millimeter and Submillimeter Wavelength

Investigating the effects of sum-frequency conversions and surface impedance uniformity in traveling wave superconducting parametric amplifiers

Dependence of Noise Temperature of Quasi-Optical Superconducting Hot-Electron Bolometer Mixers on Bath Temperature and Optical-Axis Displacement