Abstract:Optical fiber temperature sensors have been widely employed in enormous areas ranging from electric power industry, medical treatment, ocean dynamics to aerospace. Recently, graphene optical fiber temperature sensors attract tremendous attention for their merits of simple structure and direct power detecting ability. However, these sensors based on transfer techniques still have limitations in the relatively low sensitivity or distortion of the transmission characteristics, due to the unsuitable Fermi level of graphene and the destruction of fiber structure, respectively. Here, we propose a tunable and highly sensitive temperature sensor based on graphene photonic crystal fiber (Gr-PCF) with the non-destructive integration of graphene into the holes of PCF. This hybrid structure promises the intact fiber structure and transmission mode, which efficiently enhances the temperature detection ability of graphene. From our simulation, we find that the temperature sensitivity can be electrically tuned over four orders of magnitude and achieve up to ∼ 3.34 × 10−3 dB/(cm⋅°C) when the graphene Fermi level is ∼ 35 meV higher than half the incident photon energy. Additionally, this sensitivity can be further improved by ∼ 10 times through optimizing the PCF structure (such as the fiber hole diameter) to enhance the light–matter interaction. Our results provide a new way for the design of the highly sensitive temperature sensors and broaden applications in all-fiber optoelectronic devices.

Demonstration of a Microelectromechanical Tunable Fabry-Pérot Cavity Based on Graphene-Bonded Fiber Devices.

All-Fiber Fabry-Perot Resonators Based on Microfiber Sagnac Loop Mirrors

Demonstration of Microfiber Knot Laser

A Simple Approach to Fiber-Based Tunable Microcavity with High Coupling Efficiency

Tunable and Highly Sensitive Temperature Sensor Based on Graphene Photonic Crystal Fiber

Experimental Demonstration of Nonlinear Enhancement in A Graphene-Deposited Microfiber

Gate‐Tunable Graphene Optical Modulator on Fiber Tip: Design and Demonstration

Inexpensive optical fiber Fabry–Perot microcavity with controllable length for sensitive temperature measurements

Microcavity-Integrated Graphene Photodetector

Silicon-Based On-Chip Tunable High-Q-Factor and Low-Power Fano Resonators with Graphene Nanoheaters

Novel Method of Fabricating Fabry-Perot Cavity Employing MEMS Wet-Etching Process

Graphene/Epoxy Composite Based Broadband All-Optical Tunable Fiber Microcavity Filter

All-Optical Tunable Fiber Filter With Dual Graphene Films Enabled by a Fiber Open Microcavity

Microfluidic Flowmeter Based On Long-Period Fiber Grating Coated With Few-Layer Graphene

Manipulation of Nonlinear Optical Properties of Graphene Bonded Fiber Devices by Thermally Engineering Fermi–Dirac Distribution

Miniature Sensor Based on Fiber-graphene-integrated NEMS

Miniature Fabry-Perot Cavity Based on Fiber Bragg Gratings Fabricated by Fs Laser Micromachining Technique

Miniature Optical Fiber Current Sensor Based on A Graphene Membrane

Microfiber Fabry-Perot interferometer used as a temperature sensor and an optical modulator

Energy-efficient tunable silicon photonic micro-resonator with graphene transparent nano-heaters

Tunable infrared Fano resonance from graphene based hybrid grating structure with germanium substrate