Abstract:The heat transfer and flow of nanofluids in microchannel heat sink is usually numerically investigated by the single-phase model. The thermal conductivity and viscosity of nanofluids are calculated in the whole computational region because the single-phase model, assumes the nanofluids is static and nanoparticles concentration is uniform. However for the actual forced flow process, the concentration distribution of the nanofluids is not uniform. So the thermal properties of the nanofluids vary within different computational regions. With the increase of the velocity of the nanofluids, the deviation between the prediction of single-phase model and experimental results increases. In this paper, a new simulation method is proposed to consider the inhomogeneous and dynamic thermophysical properties of the nanofluids by obtaining the nonuniformly distributed nanoparticle concentration in each numerical cell. At the same time, it takes into account the following factors: the interactions between the nanoparticles, the solid wall and the base fluid, the axial conduction, the slip boundary conditions and fluid-solid coupling. The results show that the proposed numerical simulation method further improve the simulation accuracy for the forced flow and heat transfer process of nanofluids in the microchannel in a wider range. The effects of the nanoparticles concentration, Reynolds number and axial heat transfer on the thermophysical properties of the nanofluilds, the flow and heat transfer characteristics of a rectangular microchannels with hydraulic dimensions of 341μm were analyzed using the proposed simulation model. The main results are as follows: the nanoparticles are enriched at the near wall for the fully developed region; the nonuniformity of the nanofluilds thermal conductivity coefficient distribution at the channel cross section increases with the increase of the mass flow rate and the inlet centration; under the same Reynolds number, the higher the nanofluids concentration the better the heat transfer characteristics, but there is no linear relationship between the enhancement amplitude and concentration; the heat transfer coefficient of nanofluid with 1% and 2% alumina nanoparticles concentration is about 5.86% and 8.49% higher than that of deionized water, respectively; the axial conduction effect cannot be ignored for the microchannel, which significantly affects the inlet and outlet region of the microchannel especially when the Reynolds number is low. The nanofluilds temperature in the microchannel increases with the curve and does not match the conventional linear growth hypothesis.

Exact Analytical Nanofluid Flow and Heat Transfer Involving Asymmetric Wall Heat Fluxes with Nonlinear Velocity Slip

Heat Transfer of Nanofluids Considering Nanoparticle Migration and Second-Order Slip Velocity

Peristaltic Flow and Heat Transfer of Nanofluids in a Sinusoidal Wall Channel: Two-Phase Analytical Study

Molecular Dynamics Simulations of Coupling Between Flow and Heat Transfer in A Nanochannel

Fluid Heat Transfer Characteristics with Viscous Heating in the Slip Flow Region

Molecular Dynamics Simulation on Fluid Flow and Heat Transfer in Rough Nanochannels

An Analytical Solution of Convective Heat Transfer in Microchannel or Nanochannel

The nanofluid flows in the channel with linearly varying wall temperature

Theoretical Conclusions About The Claims Of Anomalous Heat Transfer Enhancement Associated With Nanofluids

Peristaltic Carreau-Yasuda nanofluid flow and mixed heat transfer analysis in an asymmetric vertical and tapered wavy wall channel

Modeling Heat Transfer of Nanofluid Flow in Microchannels with Electrokinetic and Slippery Effects Using Buongiorno’s Model

Hydromagnetic Flow and Heat Transfer with Various Nanoparticle Additives Past A Wedge with High Order Velocity Slip and Temperature Jump

Effects of Second-Order Velocity Slip and the Different Spherical Nanoparticles on Nanofluid Flow.

A Non-Newtonian Magnetohydrodynamics (MHD) Nanofluid Flow and Heat Transfer with Nonlinear Slip and Temperature Jump

Heat Transfer Enhancement in Microchannels by Utilizing the Al 2 O 3 -Water Nanofluid

A Molecular Dynamics Simulation on the Convective Heat Transfer in Nanochannels

Analytical Solutions of Slip Flow and H1 Heat Transfer in Elliptical Microchannels

An Approach on Turbulent Flow of Pseudo-Plastic Nanofluids and Heat Transfer Subject to Wall Slip

Slip Effects on Heat and Mass Transfer of a Non-newtonian Fluid in the Micro-channel

Numerical Investigation of Laminar Convective Heat Transfer and Pressure Drop of Water-Based Al 2 O 3 Nanofluids in a Microchannel

Second-Order Slip Effects on Heat Transfer of Nanofluid with Reynolds Model of Viscosity in A Coaxial Cylinder