Abstract:HCCI (Homogeneous Charge Compression Ignition) combustion has the potential to significantly reduce NOx and PM emission of diesel engines due to its nature of even mixture and low temperature combustion. This combustion mode is only applicable in part load and low speed area so far. This range limitation results in frequently combustion mode switching from HCCI to CI and vice versa in real applications. HCCI realized by late injection with heavy EGR rate is investigated, which is also named PCCI (Premixed Charged Compression Ignition) sometimes. By changing control parameters (including injection timing, injection pressure and EGR rate) individually, the influences of these parameters on HCCI combustion and emissions are identified. Based on the evaluation of the influences, one pre-defined step-by-step air-fuel coordination strategy is presented. Additionally one hysteresis combustion mode determination method is proposed to avoid target mode fluctuation due to variation of engine speed or engine load in a small range. Torque deficiency occurs in acceleration transients as a result of fuel limitation to reduce soot emission, especially during HCCI to Cl transitions. One ISG (Integrated Starter Generator) motor is applied to perform dynamic torque compensations in transient operations. Engine friction torque is estimated by means of cylinder pressure information from in-cylinder pressure sensors. On the basis of torque estimation, the difference between desired engine brake torque and actual engine brake torque is obtained. The torque output of ISG motor accounts for this torque gap and the torque pre distributed to ISG motor. The strategy is verified by engine tests. Experimental results indicate that, with the finely defined air-fuel coordination, less unstable combustion occurs and the target modes are established more quickly during transitions both in steady states and in transients. The torque deficiency during acceleration operations could be well compensated by the ISG motor. (C) 2013 Elsevier Ltd. All rights reserved.

SI/HCCI Mode Switching Optimization in a Gasoline Direct Injection Engine Employing Dual Univalve System

Mode switch of SI-HCCI combustion on a GDI engine

Study of SI-HCCI-SI Mode Switching in a GDI Engine

Effects of Key Factors on the Engine Combustion Mode Switching Between HCCI and SI

Combustion Mode Switching Control in A Hcci Diesel Engine

Control of a spark ignition homogeneous charge compression ignition mode transition on a gasoline direct injection engine

Control of HCCI engine fueled with gasoline with electro-hydraulic variable valve system

Fuel injection and EGR control strategy on smooth switching of CI/HCCI mode in a diesel engine

Realization and Control of SI/HCCI Mode Switch on a GDI Engine

Research on steady and transient performance of an HCCI engine with gasoline direct injection

Experimental Research on Mode Switch in a Multi-Cylinder HCCI Engine

Study of Multimode Combustion System with Gasoline Direct Injection

Study on the Transition Mode of Ethanol SI-HCCI-SI Combustion Mode Transition

New Gasoline Homogeneous Charge Compression Ignition Combustion System Using Two-State Direct Injection and Assisted Spark Ignition

An Investigation into the Operating Mode Transitions of a Homogeneous Charge Compression Ignition Engine Using EGR Trapping

Gasoline-diesel Dual Fuel Intelligent Charge Compression Ignition (ICCI) Combustion: Conceptual Model and Comparison with Other Advanced Combustion Modes

A Modelling Study into the Effects of Variable Valve Timing on the Gas Exchange Process and Performance of a 4-Valve DI Homogeneous Charge Compression Ignition (HCCI) Engine

Modeling and Optimization of the SI/HCCI Mode Transient Switching

Control system development for gasoline HCCI engine which based on heat management

Dual Fuel Intelligent Charge Compression Ignition (ICCI) Combustion: Efficient and Clean Combustion Technology for Compression Ignition Engines

Multiple-objective optimization of Jet Controlled Compression Ignition (JCCI) mode with dual-direct injection in a high-speed light-duty engine