Abstract:Abstract Degradation of electronic equipment is typically accompanied by a deviation in their electrical parameters from their design values. When the function of the electronic equipment fails, parametric faults of the electrical parameters will ultimately occur. Such electrical parameters can characterize the state of health can be defined as health parameters. For complex electronic equipment such as hardware circuits of Nuclear power plant DCS cards, the use of health parameters for fault diagnostic has been widely used, but there is no mature method for sub-health diagnostic. To address this problem, an electronic equipment health assessment method was developed using a technology based on the combination of mechanism knowledge and data-driven. The method first uses Physics of Failure approach and hardware circuit logic principle to identify the major failure mechanisms of the circuit, and then determines the key health parameters and their sub-health thresholds on this basis. The time series data under specific test conditions for the key health parameters of the circuits to be assessed is collected and compared with the sub-health thresholds, then the health status assessment results based on mechanism knowledge can be obtained. As well, the data-driven health assessment technology based on Mahalanobis distance is applied to analyze the real-time health parameter data of all samples, and the healthy outlier samples are identified and quantified, and the health status assessment results based on the data-driven technology can be obtained. The results of the two are comprehensively evaluated to finally determine the circuit health status. Practice was carried out on the DCDC chip of a nuclear power DCS analog output module, and the results showed that this method was feasible for engineering.

A HALT-Simulation Combined Fault Diagnosis and Optimization Method for Electronic Module

Wear-out Evolution Analysis of Multiple-Bond-wires Power Modules Based on Thermo-Electro-mechanical FEM Simulation

Study on Fault-Tolerant Based on Modular Method in the Development of Test and Control System Software

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

Unified Strategy for Fault-Tolerant Operation of MMC with Multiple SMs Failure Based on SMs Grouping Management

A Submodule Fault Ride-Through Strategy for Modular Multilevel Converters with Nearest Level Modulation

A Statistical Submodule Open-circuit Failure Diagnosis Method for MMCs Enabling Failure Detection, Localization and Classification

Redundancy Fault-tolerated Control Strategy for Sub-module Faults of Modular Multilevel Converters

Health-assessment Methodology Research for SMPS Based on Simulation

Research on a Circuit Health Assessment Technology Combining Mechanism Knowledge and Data Driven Technology

Detection and Localization of Submodule Open-Circuit Failures for Modular Multilevel Converters with Single Ring Theorem

Cumulative Fatigue Damage Balancing for Modular Multilevel Converter

Reliability Analysis and Structural Optimization of Circuit Board Based on Vibration Mode Analysis and Random Vibration

A Threshold Adaptive Open-Circuit Submodule Fault Diagnosis Strategy for Modular Multilevel Converters

Solder Defect Assessment Method for Power Electronic Devices Based on Mechanical Stress Wave Signals

Understanding board level vibrations in automotive electronic modules

A Fault Tolerant Control For Modular Multilevel Converter Under Submodule Fault Conditions

Fault-Tolerant Control of Medium-Voltage Modular Multilevel Converters with Minimum Performance Degradation under Submodule Failures

Reliability Test of Aircraft Integrated Electronic Assemblies Based on Virtual Qualification Method

Anti-Defect Design for Mechanical Elements under Severe Condition Based on a Half-Real Defect Model

Printed-Circuit Board Model Establishment and Solder Joint Failure Analysis