Abstract:In this paper, we present a vibration-based transmission tower structural health monitoring system consisting of two parts that identifies structural changes in towers. An accelerometer group realizes vibration response acquisition at different positions and reduces the risk of data loss by data compression technology. A solar cell provides the power supply. An analyser receives the data from the acceleration sensor group and calculates the transmission tower natural frequencies, and the change in the structure is determined based on natural frequencies. Then, the data are sent to the monitoring center. Furthermore, analysis of the vibration signal and the calculation method of natural frequencies are proposed. The response and natural frequencies of vibration at different wind speeds are analysed by time-domain signal, power spectral density (PSD), root mean square (RMS) and short-time Fouier transform (STFT). The natural frequency identification of the overall structure by the stochastic subspace identification (SSI) method reveals that the number of natural frequencies that can be calculated at different wind speeds is different, but the 2nd, 3rd and 4th natural frequencies can be excited. Finally, the system was tested on a 110 kV experimental transmission line. After 18 h of experimentation, the natural frequency of the overall structure of the transmission tower was determined before and after the tower leg was lifted. The results show that before and after the tower leg is lifted, the natural frequencies of each order exhibit obvious changes, and the differences in the average values can be used as the basis for judging the structural changes of the tower.

Vibration Analysis of an Axially Moving Plate Based on Sound Time-Frequency Analysis

On the Analysis of A Piecewise Nonlinear-Linear Vibration Isolator with High-Static-Low-Dynamic-Stiffness under Base Excitation

Vibration characteristics and isolation in vibration-sensitive areas under moving vehicle load

Application of the HHT Method to the Non-contact Thickness Measurement of an Axially Moving Thin Plate

Response Adjustable Performance of a Visco-Elastomer Sandwich Plate with Harmonic Parameters and Distributed Supported Masses under Random Loading

Detection and Analysis of Fault for HTS AMDT Cores by Magnetostriction-Induced Vibration

Time and Frequency Analysis of Vibration Signals for Testing Motion Equipment of Lithography

An Analysis of Thickness-shear Vibrations of an Annular Plate with the Mindlin Plate Equations

Time-domain Structural-Acoustic Analysis of Composite Plates Subjected to Moving Dynamic Loads

Time–frequency Analysis of Nonstationary Vibration Signals for Deployable Structures by Using the Constant-Q Nonstationary Gabor Transform

Hilbert–Huang Transform-Based Vibration Signal Analysis for Machine Health Monitoring

Vibration Analysis of Micro-Plate Using Modified Cosserat Theory and Differential Quadrature Method

A Vibration-Based Structural Health Monitoring System for Transmission Line Towers

The Antiplane Vibration of Mass Sensor with an Inhomogeneous Weak Interface

Nonstationary Vibration Signal Analysis Using Wavelet-Based Time–Frequency Filter and Wigner–Ville Distribution

Analysis of Vibration Characteristics of Spatial Non-Uniform Tensioned Thin-Film Structures Based on the Absolute Nodal Coordinate Formulation

The Anti-Plane Vibration of a Quartz Plate with an Additional Partial Non-Uniform Mass Layer for Acoustic Wave Sensing

Analysis of Material Movement on a Vertically Vibratory Plate with Anisotropic Friction Surface

ANALYSIS OF LATERAL VIBRATION OF A RECTANGULAR PLATE SUPPORTED AT FOUR CORNER POINTS WITH AN ADDITIONAL CONCENTRATED MASS BASED ON THE RAYLEIGH–RITZ METHOD

Vibration Analysis of Ball Bearing Considering Waviness under High Speed and an Axial Load

SCALE EFFECT ANALYSIS FOR THE VIBRO-ACOUSTIC PERFORMANCE OF A MICRO-PLATE