Abstract:Dimethyl ether (DME) is a highly reactive diesel substitute that can be used as a pilot fuel to ignite low- reactivity methane (CH4) in heavy-duty engines. To optimize the efficiency and emissions of CH4/DME dual-fuel engines, it is crucial to study the fundamental combustion characteristics of DME mixed with methane. This study focuses on the influence of CH4 addition on the low-temperature oxidation (LTO) preparation stage and the thermal ignition (TI) preparation stage of DME in the two-stage ignition process, as these two stages respectively control the ignition delay of the first and second stages. The comparison is made between pure DME and a 50% CH4 and 50% DME blended fuel, operating under thermodynamic conditions representing the engine in- cylinder environment at 30 atm pressure, 650K temperature, and a stoichiometric equivalence ratio. The results show that the addition of methane hardly affects the control mechanism of the two-stage ignition of DME. Specifically, the LTO preparation stage is still promoted by the increase in OH radicals in the DME’s low-temperature oxygenation pathways to form KET, and the second stage is still controlled by the H2O2 loop mechanism. The kinetic analysis also reveals that methane addition can compete for some of the OH radicals in the LTO preparation stage, which has a suppressing effect on ignition. However, in the TI preparation stage, methane can promote the loop reaction of OH→HO2→H2O2→OH and promote ignition. For the operating conditions studied here, although methane consumes a total of 7.24% prior to thermal ignition, it only consumes 0.63% of the total amount in the LTO preparation stage and 1.81% of the total amount in the TI preparation stage. This indicates that methane is mainly consumed in the LTO stage, accounting for 65% of the total methane consumption amount. It can be concluded that the kinetic effect of methane has a relatively small impact on the ignition delay of the DME, at least for the conditions investigated here. In other words, the dilution and thermal effects caused by adding methane are the main reasons for the prolonged time of LTO/TI preparation. Overall, more fundamental research is warranted to understand the role of methane in the two-stage ignition process of DME, which could facilitate the development of CH4/DME dual-fuel engines.

Effect of Hydrogen Addition on Laminar Burning Velocity of CH4/DME Mixtures by Heat Flux Method and Kinetic Modeling

Experimental and Numerical Study on the Effect of Hydrogen Addition on Laminar Burning Velocity of Ethanol-Air Mixtures

Effect of Dimethyl Ether (DME) Addition on Sooting Limits in Counterflow Diffusion Flames of Ethylene at Elevated Pressures

Kinetic Modeling Study of Hydrogen Addition to Premixed Dimethyl Ether-Oxygen-argon Flames

High Temperature Ignition and Combustion Enhancement by Dimethyl Ether Addition to Methane–air Mixtures

Experimental and Kinetic Investigations of the Effect of H2/CH4/C2H4 Addition on the Burning Properties of Practical Jet Fuel

Effects of Methane Addition on the Laminar Burning Velocity and Markstein Length of Methanol/air Premixed Flame

Experimental and Kinetic Study on Laminar Burning Velocities of High Ratio Hydrogen Addition to CH4+O2+N2 and NG+O2+N2 Flames

Laminar and kinetic burning characteristics of ethanol/methane/hydrogen fuel: experimental and numerical analysis

Kinetic study of the effects of hydrogen blending to toluene reference fuel (TRF)/air mixtures on laminar burning velocity and flame structure

Effects of Hydrogen Addition on Laminar Flame Speeds of Methane, Ethane and Propane: Experimental and Numerical Analysis

Effect of DME addition on turbulent flame structure in lean premixed CH4/DME/air mixtures

Further Study on Effects of Hydrogen Addition on Laminar Flame Speeds of Fuel-Air Mixtures

Flame Structure Analysis of Turbulent Premixed/stratified Flames with H2 Addition Considering Differential Diffusion and Stretch Effects

The Effect of Methane Addition on the Low-Temperature Oxidation Preparation and the Thermal Ignition Preparation of Dimethyl Ether under Representative Engine In-Cylinder Thermal Conditions

Effect of hydrogen addition on the laminar burning velocity of n-decane/air mixtures: Experimental and numerical study

The Effects of Water Addition on the Laminar Flame Speeds of CO/H2/O2/H2O Mixtures

HDMR Correlations for the Laminar Burning Velocity of Premixed CH4/H2/O2/N2 Mixtures

Effects of Hydrogen Addition on Laminar Dilute N-Dodecane Spray Flames

Experimental and kinetic study on the laminar burning velocities of NH3 mixing with hydrous C2H5OH in premixed flames

Experimental and numerical investigations of the laminar burning velocities of premixed fuel-rich methane oxy-fuel and oxygen-enhanced flames