Abstract:The quasi-Z-source inverter (qZSI) has been widely explored for renewable energy applications due to its superiority, e.g., higher boosting ratio and operational reliability, which is attained by inserting shoot-through (ST) states. As a conventional space vector modulation (SVM) method for the three-phase qZSI, the ZSVM6 method is easy to implement by dividing the ST time into six identical intervals. However, the instantaneous inductor current ripples of the qZSI with the ZSVM6 strategy are affected by the operating conditions, e.g., modulation index m and ST duty ratio dsh. In this article, the instantaneous inductor current ripples and the maximum current ripple in the qZSI with the ZSVM6 strategy under all operational conditions are explored in detail. The operational conditions are categorized into several cases according to the relationship among the duty ratios of the active states, null states, and ST states. More importantly, an improved ZSVM6 strategy is proposed to reduce the inductor current ripple for the qZSI, in which the maximum inductor current ripple is limited by making full use of the operational states. The proposed ZSVM6 strategy keeps the total ST time in a switching cycle while maintaining the axis-symmetry feature of the inductor current, but reduces the current ripple. Simulations and experimental results confirm effectiveness of the proposal when compared with the conventional ZSVM6 strategy for ripple current reduction.

Design of SiC-Based Single-Phase Quasi-Z-Source Inverter

Impedance Network Impact on the Controller Design of the QZSI for PV Applications

Small-Signal Modeling And Experimental Validation Of The Three-Phase Quasi-Z-Source Inverter

Inductor Current Ripple Analysis and Reduction for Quasi-Z-Source Inverters With an Improved ZSVM6 Strategy

A Switched Quasi-Z-Source Inverter with Continuous Input Currents

Impact of SiC MOSFET on PV Inverter

Modified Modulation Techniques for Quasi-Z-Source Cascaded H-Bridge Inverters

100Kw Soft Switching Three-Phase Inverter with Hybrid Switches

Efficiency Improvement of 2- and 3-Level Inverters for Distributed Photovoltaic Application Using Hybrid Devices

Minimized Quasi-Z Source Network for Single-Phase Inverter

Modeling And Control Of Single-Phase Quasi-Z-Source Inverters

SiC Full-Bridge Grid-Tied Inverter with ZVS-switching

Sic Mosfet Zero-Voltage-Switching Svm Controlled Three-Phase Grid Inverter

A Three-Phase-Module-Parallel Si & SiC Hybrid Inverter with Smaller Filter Size and Low Cost

Comparison of GaN and SiC Power Devices in Application to MW-scale Quasi-Z-source Cascaded Multilevel Inverters

Modeling, Impedance Design, and Efficiency Analysis of Quasi- $Z$ Source Module in Cascaded Multilevel Photovoltaic Power System

Design of Z‐Source and Quasi‐Z‐Source Inverters

Design of Low Inductance SiC-MOS/Si-IGBT Hybrid Module for PV Inverters

Comparison of Sic and Gan Devices for Front-End Isolation of Quasi-Z-Source Cascaded Multilevel Photovoltaic Inverter

Efficiency improvement of a SiC-MOSFET 500 kHz ZVS inverter

SiC Power Devices and Applications in Quasi-Z-source Converters/inverters