Abstract:The fuel spray injected into a direct injection (DI) engine is substantially affected by both the in-cylinder air flow and the piston cavity wall impingement. The combined effect of the air flow and the wall impingement plays an important role on the spray development, mixture formation, and subsequent combustion. In this study, the effects of cross-flow and flat wall impingement on the spray development and dispersion were investigated. The spray was injected by a valve covered orifice (VCO) nozzle under various cross-flow velocities and ambient pressures. Impingement spray images in a vertical plane and several horizontal planes were obtained by a high speed video camera and a continuous wave laser sheet. A high speed video camera connected with a long-distance microscope was employed to obtain the near-field spray images. The results show that cross-flow favors spray dispersion while the high ambient pressure tends to compress the spray profiles. Additionally, under an approximate liquid-to-air momentum flux ratio q, when the ambient pressure and cross-flow velocity were varied, at 2 ms ASOI the outlines of the spray in the windward side agree well, whereas the spray extended further in the leeward side at a lower ambient pressure. At the plane of y = 25 mm, a complex vortex movement was observed that resulted in a non-uniform distribution of droplets in the upper part of the spray in the leeward side. In addition, at the plane of y = 45 mm, an empty belt area occurred in the vortex core region revealing that the density of the droplets in this region was quite low. The quantitative analysis shows that with increasing cross-flow velocity, the spray tip penetration decreases slightly before impingement while the spray tip penetrates further on the wall surface after impingement. The high cross-flow velocity favors the spray breakup and dispersion leading to a larger wall-jet vortex while the high ambient pressure restrains the spray dispersion leading to a smaller spray tip penetration and vortex height. For near-field spray, the spray image at higher ambient pressure shows fewer ligaments. With increasing cross-flow velocity, the whole spray shifted downstream. The spray outline was wider at the initial stage (0.05 ms ASOI) than that at steady stage (2 ms ASOI) of spray evolution.

Imaging of High-Pressure Fuel Sprays in the Near-Nozzle Region with Supercontinuum Illumination

Diagnosis of Liquid-Gas Mixed Sprays in the Near-Field Region Using Femtosecond Laser Induced Supercontinuum Imaging Method.

Supercontinuum-illumination for Long-Working-distance Microscopic Imaging of Air–liquid Mixed Sprays in the Near-Nozzle Region

Simultaneous high-speed internal and external flow measurements for a high-pressure diesel nozzle

Speckle-Suppressed Full-Field Imaging Through A Scattering Medium Using A Supercontinuum

Quantitative comparison of fuel spray images obtained using ultrafast coherent and incoherent double-pulsed illumination

Long-working-distance Microscopic Imaging Through a Scattering Medium Using Supercontinuum Illumination

Quantitative Characterization of Near-Field Fuel Sprays by Multi-Orifice Direct Injection Using Ultrafast X-Tomography Technique

Investigations on Near-Field Atomization of Flash Boiling Sprays for Gasoline Direct Injection Related Applications

Investigation on flash boiling spray fluctuations in the near-field and far-field under gasoline direct injection related conditions

Experimental study on microscopic characteristics of impinging spray at elevated ambient pressure conditions during development

Experimental Study on Impingement Spray and Near-Field Spray Characteristics under High-Pressure Cross-Flow Conditions

Initial Dynamic Development of Fuel Spray Analyzed by Ultra High Speed Imaging

Flow field characterization of superheated sprays from a multi-hole injector by using high-speed PIV

Conical Liquid Sheet Morphology and 3D Droplet Distribution of Aviation Kerosene Pressure-Swirl Spray with Digital Off-Axis Holography

Time-resolved Measurement of the Near-Nozzle Air Entrainment of High-Pressure Diesel Spray by High-Speed Micro-Ptv Technique

A Study of Near-field Spray Structure under Superheated Conditions of a Gasoline Fuel Spray

FLOW-FIELD INVESTIGATION OF MULTI-HOLE SUPERHEATED SPRAYS USING HIGH-SPEED PIV. PART I.CROSS-SECTIONAL DIRECTION

A morphological study of supercritical fuel flash-boiling spray

Characterization of Direct-Injection Gasoline Sprays under Different Ambient and Fuel Injection Conditions

Quantitative near-field water–air spray measurements at elevated pressures by neutron radiography imaging