Abstract:Gasification of biomass waste is considered as a green and sustainable solution to reduce waste volumes and recover energy by producing syngas. In this study, both experiment and simulation have been conducted to understand the various physical and chemical effects in a fixed bed downdraft gasifier and to provide researchers with a tool to overcome the need to conduct cost intensive experiments for predicting and optimizing energy efficiencies. A combined transient single particle and fuel-bed model is developed to describe the entire packed bed in the flow direction of primary air and intraparticle phenomena. The reactor is discretized and in each cell one representative particle is chosen to be modelled as shrinking sphere. The reactor was divided into three regions due to the difference of air velocity in each region: natural convection region, mixed convection region and forced convection region. Sensitivity analysis has been conducted to determine the boundary location of each region. The presented model considers drying, pyrolysis, homogeneous gas reactions, and heterogeneous combustion/gasification reactions. In the gas phase eight species (O2, N2, CO, CO2, H2, H2O, CH4 and tar) are considered. The solid phase is biomass waste, in which all the components obtained from approximate analysis (moisture, volatiles, fixed carbon and ash) and ultimate analysis (C, H, O, N) are treated as dependent variables of time and space. This model can predict production rate and quality of both synthetic gas and produced char from gasifier reactor. The optimized biomass properties, equivalence ratio and air inlet location for maximum energy efficiency can also be obtained from this model. Experiments have been conducted to investigate the effects of different parameters on gasification performance, such as biomass moisture content, particle size and shape, equivalence ratio, etc. The experimental results are also used to validate against simulation results and the deviation between the numerical and experimental results obtained in this study is lower than 10%.

Computational Fluid Dynamics Model on Updraft Gasifier Using Carbonized Woody Briquette As Fuel

Assessment of the Carbonized Woody Briquette Gasification in an Updraft Fixed Bed Gasifier Using the Euler-Euler Model

CFD Simulation of the Steam Gasification of Millimeter-Sized Char Particle Using Thermally Thick Treatment

Multi-Scale Simulation of Biomass Gasification in Fluidized Beds

Biomass Gasification in a Fixed Bed Downdraft Gasifier: Experimental Study and Comprehensive Reactor and Particle Modelling

Modeling and Simulation of Biomass Air-Steam Gasification in a Fluidized Bed

CFD Modelling of the Co-Gasification of Biomass and Coal Particles in Fluidised Beds

Modelling of Down-Draft Gasification of Biomass – an Integrated Pyrolysis, Combustion and Reduction Process

Numerical modeling of a jetting fluidized bed gasifier and the comparison with the experimental data

Numerical simulation of gasification characteristics in a circulating fluidized bed biomass gasifiers

Numerical simulation of a new two-stage dry feed gasifier for double-high coal

Model-based Downdraft Biomass Gasifier Operation and Design for Synthetic Gas Production

Simulation of co-gasification of coal and wood in a dual fluidized bed system

3D numerical simulation of Texaco gasifier using assumed PDF model

Modeling Biomass Gasification in Circulating Fluidized Beds

Assessment of Coal Gasification in a Pressurized Fixed Bed Gasifier Using an ASPEN Plus and Euler–Euler Model

CFD Modeling of Sawdust Gasification in a Lab-Scale Entrained Flow Reactor Based on Char Intrinsic Kinetics. Part 1: Model Development

Computational Fluid Dynamics Modeling of Coal Gasification in a Pressurized Spout-Fluid Bed

Performance Study of a Woody Downdraft Gasifier: Numerical Investigation and Experimental Validation

2-D CFD modeling of gasification of a large biomass char particle in CO2 environment

Kinetic Model and CFD Simulation for an Entrained Flow Coal Hydrogasifier and Influence of Structural Parameters