Abstract:FEC 2023 contribution: Experiments in DIII-D document the ITER Baseline Scenario (IBS) at q95 ~ 3 and PIN/PLH ~ 1-2, in both deuterium and hydrogen utilizing Kr and Xe as Tungsten-equivalent radiators. The power threshold for H-mode operation (PLH) was found to be about a factor of two higher than the scaling law. In recent IBS experiments in deuterium, intrinsic levels of metals such as Tungsten (W) or molybdenum and inconel are present that reduce the pedestal pressure by 20-25%. A complete radiative collapse of deuterium IBS plasmas occurs at W core concentrations CW = 10-5. Simulations show that for core temperatures expected for ITER, the plasmas would not have a radiative collapse at CW = 1x10-5, moreover Q = 8-10 would still be achieved for CW up to 3x10-5. In contrast to deuterium, the IBS in hydrogen is not affected by intrinsic high-Z impurities. Krypton was injected in a matrix scan of input power and impurity flow in IBS hydrogen discharges. Krypton impurity density profiles in hydrogen are similar to deuterium plasmas, but at Kr flows that are 2-3 times higher for the same input power. Krypton is transported into the core and affects the whole radius; at the highest injection rates a radiative collapse occurs at core radiation fractions of 0.3-0.35, consistent with the expected maximum W radiation fraction for ITER core plasmas. Comparing the results with previous ITPA database studies of the IBS confirms that at higher radiation fraction due to high-Z impurities, a drop in H98 of >10% is observed. On the other hand, the results using Kr as a W-equivalent radiator indicate that metal (W) devices at lower core temperatures than ITER may provide overly pessimistic performance extrapolations to ITER for deuterium-tritium operation.

An Improved Method for Modelling Coolant Radiolysis in ITER

Analysis and Optimization of Cooling Channels in ITER Blanket Module

MCNP Models for Tokamak Cooling Water System Equipment Evaluations

Cooling Circuit Development of Equatorial Diagnostic Port Plug Dedicated to International Thermonuclear Experimental Reactor

Prediction of Flow and Temperature Distributions in a High Flux Research Reactor Using the Porous Media Approach

Activation Analysis of Coolant in a Water-Cooled Loop of China Fusion Engineering Test Reactor

Numerical Simulation in A Subcooled Water Flow Boiling for One-Sided High Heat Flux in Reactor Divertor

CFD simulation on the transient process of coolant mixing phenomenon in reactor pressure vessel

Numerical Investigation on the Thermal-Hydraulic Characteristics near a Corroded Lower Head of the Reactor Vessel During IVR-ERVC

Computational model for thermohydraulic analysis of an integral pressurized water reactor with mixed oxide fuel (Th, Pu)O2

Design and Evaluation of Mitigation Measures for Tsinghua High Flux Reactor Loss-of-Coolant Accidents

Predictive Modeling for Performance Assessment of ITER-Like Divertor in China Fusion Engineering Testing Reactor

Optimization of structural parameters of an inner preheating transpiring-wall SCWO reactor

Numerical Simulation Of A Transpiring Wall Reactor

A Model for Radiolysis in a Flowing-Water Target during High-Intensity Proton Irradiation.

Three-dimensional modeling and thermal hydraulic analysis of high temperature gas-cooled reactor core

Experimental Investigation on Heat Transfer Characteristics in a Safety Injection Nozzle Component in PWR

Modeling and Analysis of Tritium Transport for Updated WCCB Blanket of CFETR

Integrated Modeling of Second Phase Precipitation in Cold-Worked 316 Stainless Steels under Irradiation

Long-Term Oxidation of Zirconium Alloy in Simulated Nuclear Reactor Primary Coolant—Experiments and Modeling

Power and isotope effects in the ITER Baseline Scenario with tungsten and tungsten-equivalent radiators in DIII-D