Abstract:Laser peen forming (LPF) is a purely mechanical forming method achieved through the use of laser energy to form complex shapes or to modify curvatures. It is flexible and independent of tool inaccuracies that result from wear and deflection. Its nonthermal process makes it possible to form without material degradation or even improve them by inducing compressive stress over the target surface. In the present study, a fully three-dimensional numerical model is developed to simulate the forming process of laser peen forming. The simulation procedure is composed of several steps mainly including the shock pressure prediction, the modal analysis, and the forming process calculation. System critical damping is introduced to prevent unnecessary long post-shock residual oscillations and to greatly decrease the solution time for simulation. The bending profiles and angles with different thicknesses are experimentally measured at different scanning lines and scanning velocities to understand the process and validate the numerical model. The calculated bending profiles and angles agree well with the trend of the measured results. But it is found that simulations with the Johnson-Cook model are more consistent, matching the experimental results for the thick sheet metal with a convex bending, while the elastic-perfectly-plastic model produces a better agreement even though with underestimated values for the thinner sheet metal with a concave bending. The reason for this phenomenon is discussed, combining the effects of strain rate and feature size. Both the simulation and the experiments show that a continuous decrease in bending angle from concave to convex is observed with increasing specimen thickness in general. Large bending distortion is easier to induce by generating a concave curvature with LPF, and the angle of bending distortion depends on the number of laser shocks. [DOI: 10.1115/1.4002585]

Experimental investigation and numerical simulation of one novel incremental bending process

Multi-point incremental bending of doubly curved high strength steel sheet under minimum strain energy loading path

Research on Sheet Metal Digital Incremental Forming Technology without Support

Experimental and Finite Element Investigation of Over-Bending Phenomenon in Double-Sided Incremental Forming (DSIF) of Aluminium Sheets

Research on Bending Forming Method of Large Diameter-Thickness Ratio Thin-Walled Tubes for Aerospace

A New Approach of Die Shape Optimization for Sheet Metal Forming Processes

An Investigation of the Induction Heating Forming Process of Hull Curved Plate

Research on the Mechanism and Processability of Roll Forming

Deformation Behavior of Curved Shells in Multi-Point Forming with Asymmetric Punches

Laser Forming of Doubly Curved Plates Using Minimum Energy Principle and Comprehensive Strain Control

Automated Local Line Rolling Forming and Simplified Deformation Simulation Method for Complex Curvature Plate of Ships

Recent Development of Incremental Forming

Evaluation on Dimpling and Geometrical Profile of Curved Surface Shell by Hydroforming with Reconfigurable Multipoint Tool

Numerical Simulation and Process Improvement of a Typical Car Thread Plate

A Study on Bending Direction of Sheet Metal in Laser Forming

Thickness Control in A New Flexible Hybrid Incremental Sheet Forming Process

Investigations on a Novel Double-Surface Single Point Incremental Forming Process for Sharp-Corner Features

Study on Roll Forming Process Simulation and Roll Diameters Optimization

Three-dimensional numerical simulation and experimental study of sheet metal bending by laser peen forming

Multi-point die electromagnetic incremental forming for large-sized sheet metals

Processing-Scheme Design for Forming Curved Ship Plate and Analysis of Calculation Cases