Abstract:Recent years have seen increased interest in dedicated exhaust gas recirculation (D-EGR) systems integrated with reciprocating engines. By dedicating one cylinder to operate at fuel rich conditions, hydrogen is generated for use in the remaining cylinders to optimize combustion and mitigate pollutant emissions. In this study, experiments were performed using a rapid compression machine (RCM) to investigate the effects of hydrogen and carbon monoxide on methane ignition and flame propagation at fuel rich and stoichiometric conditions relevant to D-EGR engines. The experiments were conducted over a range of temperatures (T = 860–1080 K) and equivalence ratios (ϕ = 1.0–1.5) and at a pressure of P = 20 atm. The results showed hydrogen addition had little effect on ignition delay time at lower temperatures (T < 950 K), but hydrogen significantly promoted ignition at higher temperatures (T > 950 K). Carbon monoxide had little effect on ignition delay times at all conditions studied. Combustion products were acquired using a fast sampling system and analyzed using gas chromatography. The results showed at ϕ = 1.4 the hydrogen mole fraction was a maximum of 8.0% of the products of rich combustion which was consistent with predictions based on chemical equilibrium calculations and model simulation results. High speed images were taken to quantify the impact of equivalence ratio on flame speed for spark-ignited mixtures in RCM experiments using mixtures similar to those expected in the D-EGR and stoichiometric cylinders. The results indicated the H2 in the D-EGR promoted the combustion process in the stoichiometric cylinder, increasing flame speed and decreasing combustion duration. Specifically, when the equivalence ratio in the D-EGR cylinder was ϕ = 1.3, the flame speed increased by about 40% compared with ϕ = 1.0. However, higher equivalence ratios reduced the flame speed and thus adversely affected combustion in the D-EGR cylinder. The results indicate stability and effectiveness of the combustion in the D-EGR cylinder could be a major concern for D-EGR natural gas engines, and optimizing the equivalence ratio of the D-EGR cylinder is critical for D-EGR to enhance combustion performance in the engine overall.

Hydrogen formation from methane rich combustion under high pressure and high temperature conditions

The Characteristics of Sorption Enhanced Steam Methane Reforming for Hydrogen Production on a Complex Catalyst

Hydrogen Production from Ammonia-Rich Combustion for Fuel Reforming under High Temperature and High Pressure Conditions

The Effects of CO2/CH4 Ratio on Soot Formation for Autothermal Reforming of Methane at Elevated Pressure

Study on Combustion Characteristics of Natural Gas-Hydrogen-Air Mixtures

A Rapid Compression Machine Study of Autoignition, Spark-Ignition and Flame Propagation Characteristics of H2/CH4/CO/air Mixtures

Study on mechanisms of methane/hydrogen blended combustion using reactive molecular dynamics simulation

Ignition of hydrogen-enriched methane by heated air

Characteristics of Explosion Hazards in Methane–Air Mixtures Diluted by Hydrogen

Experimental and modeling study on ignition delays of lean mixtures of methane, hydrogen, oxygen, and argon at elevated pressures

Determination of Hydrogen Production from Rich Filtration Combustion with Detailed Kinetics Based CFD Method

Numerical Simulation of Methane-Hydrogen-air Premixed Combustion in Turbulence

Numerical Study of Combustion and Emission Characteristics for Hydrogen Mixed Fuel in the Methane-Fueled Gas Turbine Combustor

Experimental Study on Combustion and Emission Characteristics of a Hydrogen-Enriched Compressed Natural Gas Engine under Idling Condition

Effect of hydrogen direct injection on natural gas/hydrogen engine performance under high compression-ratio conditions

Visualization study on the ignition and combustion characteristics of methane/hydrogen ignited by diesel

Effects of Hydrogen Addition on Methane Catalytic Combustion in a Microtube

Study of CH4-H2-CO-Air premixed combustion characteristics based on fractal dimension and flame crack method

Understanding of gas-phase methane pyrolysis towards hydrogen and solid carbon with detailed kinetic simulations and experiments

Experimental and Kinetic Study on Laminar Burning Velocities of High Ratio Hydrogen Addition to CH4+O2+N2 and NG+O2+N2 Flames

Fundamental Combustion Properties of H2/CO Mixtures: Ignition and Flame Propagation at Elevated Pressures