Abstract:The fracture toughness of pressure pipe steels is vital for their design and safe operation. Understanding the deterioration of the fracture toughness and the corresponding fracture mechanisms is instructive and meaningful for material selection and development. The elastic-plastic fracture toughness of 9% Cr steels aged at 873 K and 923 K from the initial state to 20000 h was investigated at ambient temperature and 873 K. The deterioration of the fracture toughness and the corresponding fracture mechanisms are discussed in detail. For 9% Cr steels, voids mainly initiated from primary inclusions such as silicides, sulfides, alumina and manganides in as-received state, while voids initiated from both primary inclusions and secondary particles such as the Laves phase after longterm aging. These voids grew and coalesced with neighboring voids and crack tips subsequently until ultimately fracture. After aging at 873 K, the fracture toughness values tested at 873 K decreased from the initial state to 3000 h and then increased to 10000 h. The peculiar deterioration of the fracture properties after 3000 h of aging at 873 K can be attributed to the high number density of Laves phase particles in the steels. It was found that the densely distributed hard Laves phase particles induced strain concentration at the interface between the Laves phase and the matrix under plane-strain tension condition and promoted nucleation of voids. It was suggested that the spatial distribution of the Laves phase played a significant role on the void formation. 9% Cr steels with a denser distribution of Laves phases brings about voids with shorter interspaces, which are more susceptible to coalesce into crack tip, resulting in lower fracture resistance. After aging at 923 K from 10000 h to 20000 h, the number density, size and volume fraction of precipitates, block size, misorientation angle and dislocation density remained almost constant. The slight increase in the fracture toughness from 10000 h to 20000 h can be mainly ascribed to the coarsening of the martensite lath in this stage.

The Effect of Microstructure Evolution on the Mechanical Properties of Martensite Ferritic Steel During Long-Term Aging

Effect of Long-Term Thermal Aging on Microstructure Evolution and Creep Deformation Behavior of a Novel 11Cr-3W-3Co Martensite Ferritic Steel

Nano-sized MX carbonitrides contribute to the stability of mechanical properties of martensite ferritic steel in the later stages of long-term aging

Microstructural Evolution and Mechanical Properties of Ultrafine-Grained Ferritic-Martensitic Steel During Thermal Aging

Effect of microstructural evolution on high-temperature strength of 9Cr-3W-3Co martensitic heat resistant steel under different aging conditions

Effects of Microstructure Evolution on the Deformation Mechanisms and Tensile Properties of a New Ni-base Superalloy During Aging at 800 °C

Effect of aging temperature on the heterogeneous microstructure and mechanical properties of a 12Cr–10Ni–Mo–Ti maraging steel for cryogenic applications

Effect of Stress on Microstructural Evolution and Mechanical Properties of 12cr3w3co Steel During Aging and Short-Term Creep

Microstructure evolution and mechanical behavior of Fe-Mn-Al-C low-density steel upon aging

Effect of aging temperature on the austenite reversion and mechanical properties of a Fe–10Cr–10Ni cryogenic maraging steel

Effect of long-term aging on the low cycle fatigue behavior and microstructure of a 10% Cr martensitic steel with low nitrogen and high boron contents at 650 °C

Effects of Aging on Microstructure and Mechanical Property of Ultralow Carbon Acicular Ferrite Steel

Evolution of strengthening factors during long-term aging at 650 °C in advanced 10% Cr heat-resistant steel

Characterization and Numerical Simulation of Nucleation–growth–coarsening Kinetics of Precipitates in G115 Martensitic Heat Resistance Steel During Long-Term Aging

Effect of Long-Term Aging on Microstructure and Local Behavior in the Heat-Affected Zone of a Ni–Cr–Mo–V Steel Welded Joint

Impacts of Aging Treatments on the Microstructural Evolutions, Mechanical Properties and Strengthening Mechanism in 1Cr15ni36w3ti

Effect of Long-Term Aging on the Microstructure Evolution and Fracture Mechanism of 9% Cr Steels

Interpretation of microstructure evolution and mechanical properties under aging treatments of a Fe–24Mn-0.6C–2Al-0.6V austenitic steel for cryogenic application

Effect of Aging on Martensitic Transformation and Superelasticity of TiNiCr Shape Memory Alloy

Effect of Microstructural Evolution and Mechanical Properties of Haynes 230 Superalloy During Long-Term Aging at 700 °C

Microstructure Evolution and Mechanical Properties during Long-term Tempering of a Low Carbon Martensitic Stainless Bearing Steel