Abstract:The solid oxide fuel cell (SOFC) is an environmentally-friendly, highly efficient, and fuel adaptable electrochemical conversion device. The Cu-CeO2 material has been recognized as a promising anode material for SOFCs. Although Cu is not a good enough oxidation catalyst, and has a relatively low catalytic activity, a combination of Cu and CeO2 can strengthen catalytic activity and overcome the problems associated with either Cu or CeO2 individually. Our density functional theory (DFT) calculations illustrate that a Cu cluster supported on CeO2(111) suppresses the formation of interface oxygen vacancies, while also enhancing the catalytic activity, and reduces the energy barrier of the H-2 oxidation reaction process compared to that of stoichiometric CeO2(111). The three phase boundary (TPB) pathway with the highest energy barrier of 0.836 eV is obviously much lower than the stoichiometric CeO2(111) equivalent with the highest energy barrier of 2.399 eV. Experimentally, temperature programmed reduction (TPR) experiments establish that Cu particles can reduce the reduction reaction temperature for ceria and increase the amount of reduced ceria. In addition, a dramatic comparison between pure ceria and Cu-modified ceria through electrical conductivity relaxation (ECR) experiments quantitatively demonstrates that Cu particles greatly improve the reaction kinetics with the specific oxygen surface exchange coefficient increasing from 1.012 x 10(-4) cm s(-1) of the bare ceria to 12.180 x 10(-4) cm s(-1) of the Cu-modified ceria (CeO2-Cu80), which agrees well with the results of the theoretical calculations.

A Comparative Investigation of So2 Oxidative Transfer over Cuo with A Ceo2 Surface

Oxidation transferring mechanism of SO2 in FCC flue gas over CeO2 surface

Evaluation of Crystalline Structure and SO2 Removal Capacity of a Series of MgAlFeCu Mixed Oxides As Sulfur Transfer Catalysts

Influence of the Chemical Composition of MgAlFeCu Mixed Oxides As Catalysts for SO2Removal

Synthesis, characterization and evaluation of Cu/MgAlFe as novel transfer catalyst for SOx removal

CuO, CeO2 Modified Mg–Al Spinel for Removal of SO2 from Fluid Catalytic Cracking Flue Gas

Structure and properties of MgAlCuFe complex oxide for FCC desulfurization: effect of Fe and Cu contents

MgAlFeCu Mixed Oxides for SO2 Removal Capacity: Influence of the Copper and Aluminum Incorporation Method

Soot Combustion Performance and H2-TPR Study on Ceria-Based Mixed Oxides

Study on Cuo-Ceo2/Sic Catalysts in the Sulfur-Iodine Cycle for Hydrogen Production

Synergistic Effects of CeO2/Cu2O on CO Catalytic Oxidation: Electronic Interaction and Oxygen Defect

Investigation of the Effect of Cu Addition on the SO2-resistance of a CeTi Oxide Catalyst for Selective Catalytic Reduction of NO with NH3

Comparative Study on the Catalytic CO Oxidation Properties of CuO/CeO2 Catalysts Prepared by Solid State and Wet Impregnation

Catalytic oxidative properties and characterization of CuO/CeO2 catalysts

Synergistic effects towards H2 oxidation on the Cu–CeO2 electrode: a combination study with DFT calculations and experiments

SO2 reduction for sulfur production by CO over Ce-Al-Ox composite oxide catalyst

Synergistic Effect Between Cuo and Ceo2 for Co Oxidation

Probing Different Effects of Surface MOy and Mn+ Species (M = Cu, Ni, Co, Fe) for Xmoy/ce0.9m0.1−xo2−δ Catalysts in CO Oxidation

Mechanism of Ce promoting SO2 resistance of MnO x /γ-Al2O3: An experimental and DFT study

Influence of Modification of FCC Catalyst on Its Activity and Sulfur Transfer

Influence of Modification of FCC Catalyst on the Performance of Sulfur Transfer