Abstract:The radial and axial vibration signals of a rotating machine are crucial information to understand the machine operation and to diagnose potential faults. Instead of using three single sensors to measure the horizontal, vertical and axial displacements of rotating shafts, a novel non-projection vision-based system was proposed to realize simultaneous measurement of the radial and axial displacements with high accuracy and good reliability using an tailored artificial constant density sinusoidal fringe pattern (CDSFP), which was pasted around the shaft surface and worked as a tri-axial (i.e. the horizontal, vertical and axial) displacement sensor. The measurement principle and setup of the proposed measurement system were well established. The horizontal displacement could be correctly obtained from the fringe period density changes of the CDSFP image sequence recorded by a high-speed camera. Simultaneously, the vertical displacement could be acquired by tracking the centerline of shaft whilst the axial displacement could be obtained by locating the peaks of the cross-correlation sequence of the fringe intensities. A sub-pixel method was employed to improve the displacement resolution of the developed system. The performance of the proposed system was demonstrated by the comparison of the experiments using eddy current sensors. It showed that the proposed method was an effective and accurate technique for real-time tri-axial vibration monitoring of rotating shaft. Experimental results verified the feasibility, effectiveness and good robustness of the proposed methodology, which demonstrated that the proposed system was capable of achieving accurate tri-axial vibration displacements of rotating shaft compared to the commercial eddy current sensor which could only measure one dimensional displacement at each measurement. Therefore, the vision-based tri-axial vibration monitoring system could be recommended for real engineering applications in condition monitoring of rotating shafts. (C) 2018 Elsevier Ltd. All rights reserved.

Radial Vibration Measurement of Rotary Shafts Through Electrostatic Sensing and Hilbert-Huang Transform

Research on an Estimate Method of Torsional Vibration for Rotating Machinery Based on HHT Analysis

Analysis of Bearing Vibration Characteristics Using Hilbert-Huang Transformation

Study on the Method of EMD-Based Vibration Signal Time-Frequency Analysis

A New Procedure for Extracting Fault Feature of Multi-Frequency Signal from Rotating Machinery

The HHT-based Analysis of Rotor Running Across Critical Rotating

Detecting a Cracked Rotor with HHT-based Time-Frequency Representation

Torsional vibration measurements on rotating shaft system using laser doppler vibrometer

Fault Diagnosis Meheod of Transverse Crack for Rotor Based on HHT

Rotational Speed Measurement Through Electrostatic Sensing and Correlation Signal Processing

Performance Assessment of the Rotational Speed Measurement System Based on a Single Electrostatic Sensor

Rotational Speed Measurement Using Electrostatic Sensors and Correlation Signal Processing Techniques.

Evaluation of the conductivity and permeability of rotor shaft material through electrical runout using FEM

Weak Faults Diagnosis for Rolling Bearings Based on Variational Hilbert Huang Transform

Real-time Three-Dimensional Vibration Monitoring of Rotating Shafts Using Constant-Density Sinusoidal Fringe Pattern As Tri-Axial Sensor

Rotational Speed Measurement Using Single and Dual Electrostatic Sensors

Rotational Speed Measurement Using Electrostatic Sensors with Single or Double Electrodes

Intelligent Condition Monitoring Of Rotating Machinery Through Electrostatic Sensing And Signal Analysis

Rotor Broken-Bar Fault Diagnosis of Induction Motor Based on HHT of the Startup Electromagnetic Torque

Orthogonal On-Rotor Sensing Vibrations for Condition Monitoring of Rotating Machines

Optimization of Electrostatic Sensors for Rotational Speed Measurement of a Metallic Rotor