Abstract:The development of fusion energy is one of the important International energy strategies with the important milestone is ITER (International Thermonuclear Experimental Reactor) project, initiated by many countries, such as: America, Europe, and Japan who agreed to set up TOKAMAK type fusion reactor in France. In ideal fusion reactor the fuel is purely deuterium, but it need higher temperature of reactor. In ITER project the fuels are deuterium and tritium which need lower temperature of the reactor. In this study tritium for fusion reactor can be produced by using reaction of lithium with neutron in the blanket region. With the tritium breeding blanket which react between Li-6 in the blanket with neutron resulted from the plasma region. In this research the material used in each layer surrounding the plasma in the reactor is optimized. Moreover, achieving self-sufficiency condition in the reactor in order tritium has enough availability to be consumed for a long time. In order to optimize Tritium Breeding Ratio (TBR) value in the fusion reactor, there are several strategies considered here. The first requirement is making variation in Li-6 enrichment to be 60%, 70%, and 90%. But, the result of that condition can not reach TBR value better than with no enrichment. Because there is reduction of Li-7 percent when increasing Li-6 percent. The other way is converting neutron multiplier material with Pb. From this, we get TBR value better with the Be as neutron multiplier. Beside of TBR value, fusion reactor can analyze the distribution of neutron flux and dose rate of neutron to know the change of neutron concentration for each layer in reactor. From the simulation in this study, 97% neutron concentration can be absorbed by material in reactor, so it is good enough. In addition, it is required to analyze spectrum neutron energy in many layers in the fusion reactor such as in blanket, coolant, and divertor. Actually material in that layer can resist in high temperature and high pressure condition for more than ten years.

Neutronics Analysis of Tritium Production Fusion Reactor Based on the Spherical Torus

Tritium Breeder Layer Evaluation of Fusion-Fission Hybrid System

A conceptual design of a spherical tokamak power plant

Optimization of Tritium Breeding Ratio in a DT and DD Submersion Tokamak Fusion Reactor

Fusion/transmutation Reactor Studies Based on the Spherical Torus Concept

Analysis of Tritium Production and Distribution in Htr-Pm

Neutronics Analyzation of Helium Cooled Solid Breeder Blanket in a Fusion Reactor

Study on tritium transport characteristics in fluoride-salt-cooled high-temperature advanced reactor

Generation and Distribution of Tritium in HTGRs and Review on the Tritiated Water Treatment Technologies

Preliminary Design of A Solid Particulate Cooled Blanket for the Steady-State Tokamak Reactor (Sstr)

Tritium Safety and Confinement Loop Design of Tritium Plant in a FPP

Neutronics Calculations of Performance Enhancement of the Lithium-Uranium Blanket of a Tokamak Reactor

Experimental study on tritium breeding in water-cooled ceramic breeder blanket mock-up under D-T neutron irradiation conditions

RESEARCH ON TRITIUM BEHAVIOR ISSUES IN HIGH-TEMPERATURE GAS-COOLED REACTORS

Optimization of tritium breeding and shielding analysis to plasma in ITER fusion reactor

Investigation on the Tritium Self-Sufficiency and Neutron Shielding Based on a Water-Cooled Blanket for CFETR at 1.5 GW

A summary of tritium behavior in nuclear power plants

The Neutronics Studies of Fusion Fission Hybrid Power Reactor

Blanket design and neutronics analysis for compact tokamak test reactor

Evaluation and Optimization of Tritium Breeding, Shielding and Nuclear Heating Performances of the Helium Cooled Solid Breeder Blanket for CFETR

Neutronics Optimization Study on the First Wall Design of CFETR for TBR Enhancement