Abstract:This paper proposes a compact three-mode base station capable of performing radar sensing, communication, and wireless power transfer (WPT) in collaboration with indoor sensor networks. With regard to the wireless sensor node, the base station transmits two-tone signals in the downlink to support its operation and provides two-way communication. The sensor node sends uplink information through backscattering using the third order intermodulation (IM3) product of the rectification. In the radar mode, a single-tone continuous wave (CW) is used to monitor if there is a moving target in the static environment. If a speed is detected, the transmit signal to the node is stopped, while the single-tone CW excitation will continue until the speed of the target is zero, and then the base station transmits a stepped frequency continuous wave (SFCW) signal to measure the distance of the target. The repeat between the two radar waveforms continues until the target is undetectable within the detection range. The software defined radio PlutoSDR is adopted as the base station. The system can wirelessly supply power and bi-directionally communicate with a CO2 sensor node 2 m away. It gives a range resolution of 2.5 cm and a minimum detectable speed of 0.25 m/s in the radar mode.

Design of RF Sampling Short Wave Reconnaissance Receiver

Research on Ultra-Short Wave Wideband Signal Reconnaissance and Control

Research of Wireless Electrocardiograph Signal Sampling System

Implementation of a New S-Band Micro-Transponder Based on Software Defined Radio

Research on High-speed Detection Method of Radar Signal Based on RFSoC.

The design of software radio receiver

A Low Cost And High Performance Design Of X-Band Short Range Doppler Radar Transceiver

Receiving MRI Echo with Software-Defined Radio Approach

Design of A New Multi-Channel Parallel Wideband Digital Radar Reconnaissance Receiver

A Joint Design of Radar Sensing, Wireless Power Transfer, and Communication Based on Reconfigurable Software Defined Radio

Design of Real-Time Data Acquisition Software in Software Defined Radio

Design of General Ground Integrated Test Intermediate Frequency Receiver for Satellite Transmission System (in Chinese)

Design of Digital Receiver for UHF RFID Reader

A Research on Adaptive Digital Filtering and Digital Demodulation Based on Software Radio Architecture

Design of Receive Channel in the Radar System Based on the Software Radio Technology

Design for the reader of UHF Radio frequency identification

A System Design for the Reader of Microwave Radio Frequency Identification

Design of the IF Receiving Module in a New Type of Ionospheric Sounding System

Design of the HF Receiver for the New Type Lonospheric Oblique Backscattering Sounding System

A High Speed Sampler for Sub-Sampling IR-UWB Receiver

Design of Parallel Multi-Channel Receiver Based on GC5016