Abstract:The results of a study on the response of a side impact beam located in a car door to impact loading is presented. The side impact beam is situated in both the front and rear side doors of a vehicle between the inner and outer shells to minimise intrusion into the passenger compartment during a collision whilst absorbing as much impact energy as possible. A numerical model of a light-weight passenger car, developed by the National Crash Analysis Center (NCAC) of The George Washington University under a contract with the Federal Highway Administration (FHWA) and National Highway Traffic Safety Administration (NHTSA) of the United States Department of Transportation (US DOT), was used to simulate a side impact on the front side door using the LS-DYNA R7.1.1 explicit solver. The resulting deformation of the door from the full vehicle model was used to design an experiment for an impact test on a passenger door to validate the simulation of an equivalent numerical model. In the experiments, the car door was subjected to a drop mass of 385 kg from a height of 1.27 m so that the maximum deflection on the car door impact test would be of similar magnitude to the maximum deflection of the door in the simulation of the full car model. Drop test experiments on beams with square and round cross-sections were carried out to validate the equivalent finite element model. The side impact beam was isolated for limited geometric optimisation with a view to improving the crashworthiness of the vehicle. The optimised compound tube configuration performed better than the single tube configuration in terms of SEA (specific energy absorbed) and maximum deflection.

Research on Structural Optimization of the Side Door Beam in SUV Based on Side Crashworthiness Simulation

A Design of Side Impact Sled Test

Frontal crashworthiness structure analysis and optimization of electric vehicle

Application of Sub-Structure Method for Automotive Side Impact Simulations

Body Structure Optimization of a Car in the Frontal Crash

Analysis and Improvement for Key Parts of Car Based on Frontal Crashworthiness Simulation

Reliability-based optimization of a novel negative Poisson's ratio door anti-collision beam under side impact

Optimization design of side airbag based on side impact simulation

Optimization Design of Body Structure in Offset Crash

Multi-objective optimization design of B-pillar and rocker sub-systems of battery electric vehicle

Simulation of Automobile Offset Frontal Impact and Structure Improvement

Analysis of Automatic Unlocking of Rear Door in Side Crash

Optimization Design of Longitudinal Beam Structure in Car Frontal Crash

Car Side Structure Crashworthiness in Pole and Moving Deformable Barrier Side Impacts

Improving Design for Crashworthiness of a Minibus

Analysis of a car door subjected to side pole impact

Finite Element Analysis on the Lateral Crashworthiness of Car Body Structure

A Study of the Vehicle Structure Crashworthiness in Dolly and Curb-Trip Rollover Tests

Crashworthiness Design Optimization for an Evtol Aircraft.

Effect of rear-seat submarine on dummy injury and it’s optimization

Research of Front-End Styling Design for a SUV Based on Pedestrian Protection