Abstract:Environmental wind tunnels for high-speed trains play a significant role in their development. The cooling system of the wind tunnel poses a challenge as it requires lower temperatures and a higher cooling capacity during operation. The conventional approach to wind tunnel refrigeration uses evaporative cooling, which is less efficient at low temperatures and comes with environmental and safety risks. In this study, we propose an innovative air compression refrigeration method based on the Brayton cycle. This method converts high-pressure air into low-temperature air at atmospheric pressure for wind tunnel refrigeration. The new cooling system has reduced energy usage by 3.72 MW, leading to a 13.15% improvement. The return cooler of the system is modeled using the effective number of heat transfer units and the mean temperature difference design method. Additionally, the turbine within the system is analyzed using one-dimensional flow characteristic analysis and the principle of similarity. This method has been validated by comparing it to other published papers. Subsequently, we perform a thorough sensitivity analysis on the key design parameters of the system. We observe that with a sufficient heat transfer area of the recooler, the cooling efficiency of the system exhibits a gradual decline from 64% to 60% as the mass flow rate of the system rises. For a fixed turbine, the cooling efficiency of the system rises from 20% to 62% and subsequently declines to 37%, with an increase in the mass flow rate. As a result, we conclude that the design parameters of the turbine have a more significant influence on the cooling efficiency of the system than the recooler. Our study will establish a foundation for selecting parameters to optimize the refrigeration system in the future.

NF-6 wind tunnel compressor and driving system

Development of a large recirculating boundary-layer wind tunnel

Φ120 Hypersonic Wind Tunnel Flow Field Calibration

Numerical Simulation and Test for a Turbine Damper

NUMERICAL INVESTIGATION OF FLOW FIELD IN A 1.5-STAGE TRANSONIC COMPRESSOR

An Aerodynamic Design and Numerical Investigation of Transonic Centrifugal Compressor Stage

Non-synchronous vibration of rotor blade in a six-stage transonic compressor

A Review on the Precise Control of the Liquid Nitrogen Supplying System in Transonic Cryogenic Wind Tunnel

Experimental Investigation of the Transonic Shock Oscillation Characteristics in a Heavy-Duty Gas Turbine Compressor Cascade

Designing an Environmental Wind Tunnel Cooling System for High-Speed Trains with Air Compression Cooling and a Sensitivity Analysis of Design Parameters

Dynamic test experiment system of single degree of freedom of Φ3.2 m wind tunnel

CFD Study on Casing Treatment in a Transonic Compressor

Design And Test Of A Novel Highly-Loaded Compressor

Investigation on the Aerodynamic Performance and Flow Mechanism of Transonic Ultra-Highly Loaded Tandem-Rotor Stage

Key scientific issues on the design and construction of large wind tunnels: summary of the 185th NFSC Shuangqing Forum

Design and Internal-flow Field Analysis of New Two-stage Centrifugal Compressor

3-D viscous numerical investigation on the overall aerodynamic performance of a transonic axial-flow compressor stage

Design and characterization of a multifunctional low-speed anechoic wind tunnel at HKUST

Numerical Investigation of Wall Heating/Cooling Effect on the Transonic Compressor Performance

A Computational Fluid Dynamics Study of Circumferential Groove Casing Treatment in A Transonic Axial Compressor

Development of a Throughflow-Based Simulation Tool for Preliminary Compressor Design Considering Blade Geometry in Gas Turbine Engine