Abstract:Abstract As an effective method of improving the attractiveness of urban public transport and alleviating urban traffic congestion, bus lanes play an important role in the urban public transport system. The research on the capacity of bus lanes is conducive to improve the operation efficiency of urban bus roads and improve the service level of urban public transport. To obtain the maximum capacity of the bus lane, on one hand, the empirical formula can be used for theoretical calculation, and on the other hand, the simulation model can be established for analysis and verification. Based on the idea of simulation, a method using Vissim is proposed, called MTCS (Minimum Traffic Capacity Substitution Method). The method divides the bus lane into different sections by intersections and stops, establishes simulation model of the bus lane to calculate the traffic capacity of each section such as vehicle speed and flow and select the minimum traffic capacity of the sections as the traffic capacity of the bus lane, which is verified by using the road saturation. The simulation process uses the actual travel speed and traffic flow of the bus lane as evaluation indicators, with the aim of maximizing the road traffic flow while the actual speed of vehicles on the road is close to the desired speed, thus achieving the desired road traffic state. To verify and improve the effectiveness of the method, its analysis results are compared with the empirical formula, and various methods of enhancing traffic capacity are quantitatively simulated. The parameters of the simulation model are set by the actual bus lane example, and the experimental results show that by the methods of modifying the stop-station mode and the signal-lamp cycle, 10% and 14% improvements can be achieved, respectively. This has a good reference value for the construction of bus lanes and the adjustment of road facilities.

Method for Computing On-Line Bus Stop Capacity

Method for calculating the capacity of bus bay

Optimizing the numbe r fo buses stopping at on-line stops under mxi ed traffic conditions

Modeling Bus Capacity for Isolated Bus Stops

A bus stop spacing optimizing model based on discrete distribution demand

Research on the multiroute probit-based public transit assignment model based on bus stop

Optimizing skip-stop operation of bus transit based on analysis of travel time

Optimal Skip-Stop Schedule under Mixed Traffic Conditions for Minimizing Travel Time of Passengers

A Method for Queue Length Estimation in an Urban Street Network Based on Roll Time Occupancy Data

Bus dwell time estimation and overtaking maneuvers analysis: A stochastic process approach

Optimization Method for Conventional Bus Stop Placement and the Bus Line Network Based on the Voronoi Diagram

Delay model in two-lane traffic flow induced by buses

Capacity of unsignalized intersection with mixed distribution headway

Optimal holding time calculation algorithm to improve the reliability of high frequency bus route considering the bus capacity constraint

MTCS: A Method of Analyzing the Traffic Capacity of Urban Bus Lane Based on Vissim Simulation

Optimization of bus stop layout considering multiple factors including passenger flow direction

Simulation Model for Estimating Bus Dwell Time by Simultaneously considering Numbers of Disembarking and Boarding Passengers

Determining the Breakpoints of Fundamental Diagrams

Survival Analysis of Bus Running Time Near Bus-Stop Areas

Passenger Boarding and Alighting Times at Bus Stops

Optimization of Public Traffic Network Based on Comfort Improvement