Abstract:This article reports an experimental study that aimed to quantitatively analyze motion coordination patterns across digits 2–5 (index to little finger), and examine the kinematic synergies during manipulative and gestic acts. Twenty-eight subjects (14 males and 14 females) performed two types of tasks, both right-handed: (1) cylinder-grasping that involved concurrent voluntary flexion of digits 2–5, and (2) voluntary flexion of individual fingers from digit 2 to 5 (i.e., one at a time). A five-camera opto-electronic motion capture system measured trajectories of 21 miniature reflective markers strategically placed on the dorsal surface landmarks of the hand. Joint angular profiles for 12 involved flexion–extension degrees of freedom (DOF's) were derived from the measured coordinates of surface markers. Principal components analysis (PCA) was used to examine the temporal covariation between joint angles. A mathematical modeling procedure, based on hyperbolic tangent functions, characterized the sigmoidal shaped angular profiles with four kinematically meaningful parameters. The PCA results showed that for all the movement trials (n=280), two principal components accounted for at least 98% of the variance. The angular profiles (n=2464) were accurately characterized, with the mean (±SD) coefficient of determination (R2) and root-mean-square-error (RMSE) being 0.95 (±0.12) and 1.03° (±0.82°), respectively. The resulting parameters which quantified both the spatial and temporal aspects of angular profiles revealed stereotypical patterns including a predominant (87% of all trials) proximal-to-distal flexion sequence and characteristic interdependence – involuntary joint flexion induced by the voluntarily flexed joint. The principal components' weights and the kinematic parameters also exhibited qualitatively similar variation patterns. Motor control interpretations and new insights regarding the underlying synergistic mechanisms, particularly in relation to previous findings on force synergies, are discussed.

Kinematics of Finger with Rolling Contact

Multi-finger Manipulation via Trajectory Optimization with Differentiable Rolling and Geometric Constraints

Design and Simulation Experiment of Rigid-Flexible Soft Humanoid Finger

Contact Constraints and Dynamical Equations in Lagrangian Systems

The Biomechanical Research of Rolling Manipulation——Kinematic Measurement and Analysis

Relative Contact Dynamics and Its Application on Manipulator'S Contact Stability Problem

Variable-Friction Finger Surfaces to Enable Within-Hand Manipulation via Gripping and Sliding

Quantitative Analysis of Finger Motion Coordination in Hand Manipulative and Gestic Acts.

Soft Finger Model with Adaptive Contact Geometry for Grasping and Manipulation Tasks

Conditions for the feasibility of multiple rolling for mechanical systems with multiple contact points

Modeling of contact pressure distribution and friction limit surfaces for soft fingers in robotic grasping

Incorporating General Contact Surfaces in the Kinematics of Tendon-Driven Rolling-Contact Joint Mechanisms

Non-jamming Conditions in Multi-Contact Rigid-Body Dynamics

On adhesive contact between spheres with rolling adhesion

In-Hand Manipulation with Soft Fingertips

Producing 3D friction loads by tracking the motion of the contact point on bodies in mutual contact

The Hand-object Kinematic Model for Bimanual Manipulation

Fingertip Contact Force Direction Control using Tactile Feedback

Experiment and Modelling of Texture and Sliding Direction Dependence on Finger Friction Behavior

Development and kinematics/statics analysis of rigid-flexible-soft hybrid finger mechanism with standard force sensor