Abstract:The corrosion behavior of reinforcing steel in concrete under dry-wet cycle condition has been studied by electrochemical noise(EN) compared with the electrochemical impedance spectroscopy(EIS),SEM micrographs and EDS.The statistical method has been employed to analyze the EN data of reinforcing steel in concrete,which revealed three different corrosion stages of reinforcing steel in concrete,including the dissolution of the passive film,the active corrosion and the cumulation of corrosion product.The wavelet transform has also been employed,which indicated that steel in concrete with pH 1 is associated with uniform corrosion,while steel in concrete with pH 3 and pH 7 are associated with localized corrosion,such as pitting corrosion.From the analysis of the shot noise theory,it was found that pitting corrosion is enhanced in pH 1 solution.Electrochemical impedance spectroscopy(EIS) also indicated that there were three corrosion stages of reinforcing steel in concrete.During the first stage,the spectrum consists of two capacitive loops,indicating that the reinforced concrete system contained two time constants.The first loop in the high frequency region was related to the capacitance and resistance of the concrete,while the second capacitive loop in the low frequency corresponding to the steel-concrete interface;during the second stage,there are three capacitive loops in the spectrum,the second capacitive loop in the intermediate frequency region should be ascribed to the rust layer of the steel;during the third stage,due to the diffusion of the corrosion product,the diameter of the semi-circles in the intermediate frequency region begins to decrease,especially in pH 1 system,it drops to very low value.

PITTING CORROSION CHARACTERS OF REINFORCING STEEL IN CEMENT MORTAR

Corrosion monitoring of reinforcing steel in cement mortar by EIS and ENA

Identification Of Reinforcing Steel'S Pitting Corrosion In Wavelet Domain

Investigation of the Filling-Overflow Behavior of Corrosion Products in Reinforced Mortar

Corrosion of Steel Embedded in Mortar and Concrete under Different Electrolytic Accelerated Corrosion Methods

THE CORROSION MONITORING USING RESISTANCE-PROBE METHOD IN THE CEMENT MOTAR AND COMPARING WITH ELECTROCHEMISTRY-PROBE METHOD

EXPERIMENTAL STUDY OF PIEZOMAGNETISM OF PITTING CORROSIONSTEEL BARS UNDER TENSILE FORCE

Electrochemical Detection for the Corrosion of Reinforcing Steel in Concrete During Immersion and Drying Cycles

Developing a Novel Expression for Chloride Ion Concentration Threshold in Reinforced Concrete: Integration of Electrochemical Analysis and Time-Dependent Modeling

In-situ monitoring of pitting corrosion of Q235 carbon steel by electrochemical noise: Wavelet and recurrence quantification analysis

Quantitative Monitoring of Pitting Corrosion Based on 3-D Cellular Automata and Real-Time ENA for RC Structures

Corrosion Monitoring Of Reinforcing Steel In Concrete By Potentialdynamic Scan Method

A New Corrosion Sensor To Determine The Start And Development Of Embedded Rebar Corrosion Process At Coastal Concrete

Mechanical Performance of Corroded Steel Bars in Concrete

On the Penetration of Corrosion Products from Reinforcing Steel into Concrete Due to Chloride-Induced Corrosion

Effect of pitting corrosion on flexural performance of RC beams

The Electrochemical Characterization of Rebar Passivation Film in Simulated Concrete Media

Study On Distribution Of Steel Corrosion Products In Concrete Structures

Non-uniform Corrosion of Steel in Mortar Induced by Impressed Current Method: an Experimental and Numerical Investigation

Study of Pitting Corrosion on Mild Steel During Wet–dry Cycles by Electrochemical Noise Analysis Based on Chaos Theory

Review on Electrochemical Detection Techniques for Corrosion of Reinforcing Steel in Concrete