Abstract:It is of great significance to accurately provide electric field information for electric power operators and electric power inspection equipment to ensure the safety of live working robots and electric power workers. In this paper, the principle of parallel plate charge induction is used to detect electric field signals and the influence of the inherent capacitance of the parallel plate on the back-end circuit is considered. An equipotential ring is used as the structure of the sensing unit to eliminate the uncertainty generated by the edge electric field. The parameters of the sensor probe are determined by the principle of differential-integration, and its structure is analyzed and designed. The consistency of the designed sensor probe was analyzed, and the results show that the consistency of the sensor is better. We have measured the sensitivity coefficients of the six probes, and the average absolute deviation reached 0.031556. The fits were all above 0.9995. In addition, a three-dimensional power frequency electric field measurement system that is easy to manufacture is designed using the hexahedral structure, which solves the problem of inaccurate electric field measurement caused by the parallel plate probe and the field source being not perpendicular, and the combined field strength formula of nonuniform electric field was obtained. In the laboratory environment, the three-dimensional power frequency electric field measurement system produced in this paper is compared with the electric field simulated by an electric field simulation tool. The test results show that the deviation between the measurement system and simulation is within ±0.55%, the measurement range is 1 kV/m–200 kV/m, the resolution is ≥1 V/m, and the maximum electric field can be measured at 200 kV/m. The nonlinear error is 2.15%, and the sensitivity coefficient is 19.10 mV / kV · m − 1 , which meets the measurement requirements of the power frequency electric field and can be applied to the actual power frequency electric field measurement.

Principles and Implementation of Four-quadrant Power Measurement for Electric Power Signals

The Power Angle and Phase Measurement Units Based Wide Area Measurement System and Its Application

A Bidirectional Electric Energy Metering Algorithm Based on the Fundamental Component Extraction and Alternating Current Sampling

An Agent-Based Distributed State Estimation Approach for Interconnected Power Systems

Electric Energy Measurement Based on the Improved Instantaneous Reactive Power Theory.

Integral Equation Technique for the Simulation of Signal Integrity and Power Integrity

The Virtual Computation for Harmonic Power Based on Phase Difference Correcting Method

Improved Power Factor Measurement Method for Low Voltage Apparatus Short Circuit Test Circuit

An Instantaneous Power Quantities Measurement Method Based on Wavelet Packet Transform

A STATE ESTIMATION METHOD OF POWER SYSTEMS BASED ON EQUIVALENT CURRENT MEASUREMENT TRANSFORMATION

An Improved Harmonic Energy Measurement Algorithm Based on Instantaneous Reactive Power Theory

Rapid Impedance Measurement Approach Based on Wideband Excitation for Single-Phase Four-Quadrant Converter of High-Speed Train

Research on power metering method for nonlinear loads in power system based on improved S-transform

Power swing detecting method using principal components analysis

Research on Perception of Power System State Based on Wams

Three-phase Measurement System for Electric Energy Parameters Based on Virtual Instrument

Application on Power Factor Through Several Survey Measure Based on DSP in Power Equipment

A STATE ESTIMATION METHOD FOR DISTRIBUTION SYSTEMS BASED ON EQUIVALENT POWER TRANSFORMATION

A new vector measurement method for power system based on all-phase Fourier transform

Research on the Three-Dimensional Power Frequency Electric Field Measurement System

A Calibration and Correction Method for the Measurement System Based on Four-Quadrant Detector