Abstract:Structural characterizations and chemisorption of O2 revealed that vanadium species in our 10% V2O5/TiO2 and 10% V2O5/γ-Al2O3 catalysts were highly dispersed polyvanadates, while that in the 10% V2O5/SiO2 was small-crystalline V2O5. Although the 10% V2O5/H–ZSM-5 exhibits strong Brønsted acidity that favors the adsorption of propylene, the poorly dispersed vanadium species makes it a poor catalyst for the conversion of propylene to acetone. The key factors determining the activity of the reaction are the number and strength of Brønsted acid sites of V–OH groups and the oxidation ability of oxidized vanadium species in the catalysts. The V2O5/TiO2 catalyst exhibits the strongest Brønsted acidity of V–OH groups in the catalysts studied, and therefore it adsorbs propylene and shows the high activity for the conversion of propylene to acetone. In fact, Fourier transform infrared indicates that the adsorption of propylene on the V2O5/TiO2 catalyst at room temperature leads to the formation of surface isopropoxy groups and adsorbed acetone. Both the 10% V2O5/γ-Al2O3 and 10% V2O5/SiO2 catalysts possess weak Brønsted acidity of V–OH groups and therefore exhibit the low activity for the conversion of propylene to acetone. Microcalorimetric adsorption of reactants and products on the catalysts provides the information about the surface bonding strengths that may be used for the microkinetic analysis of the corresponding surface reactions. The initial heat for water adsorption on the V2O5/TiO2 catalyst is lower than 90 kJ/mol, indicating that water is reversibly adsorbed at temperatures higher than 360 K. The heat of adsorption of acetone on the reduced V2O5/TiO2 catalyst is about 100 kJ/mol, which can be used to estimate the activation energy for desorption of acetone from the catalyst. O2 adsorption on the reduced catalysts produces high heat, indicating that the reoxidation of reduced vanadium species by O2 is an irreversible reaction step.

Adsorption and Reaction of C4 Hydrocarbon on VPO Catalyst

In Situ Drifts Investigation Of C4 Hydrocarbons Selective Oxidation To Ma On A Vpo Catalyst

Reaction Kinetics of N-Butane Oxidation on VPO Catalyst

Influence of the Structural Characteristics of VPO Catalysts on the Temperature Sensitivity of the Oxidation Reaction of n-Butane to Maleic Anhydride

Preparation of Novel Composite VPO/Fumed Silica Catalyst for Partial Oxidation of N-Butane

A comparison study on the partial oxidation of n-butane and propane over VPO catalysts supported on SBA-15, MCM-41, and fumed SiO2

Progress of vanadium phosphorous oxide catalyst for n-butane selective oxidation

n-Butane oxidation over VPO catalysts supported on SBA-15

Characterization and catalytic performance of supported molybdophosphoric acid catalysts for the oxidation of propylene to acetone

VPO catalysts supported on H3PO4-treated ZrO2 highly active for n-butane oxidation

On-Line Mass Spectroscopic Transient Measurement of Vanadium-Phosphorous Oxide Re-Oxidation

A vanadium phosphorus oxide catalyst synthesized in rotating packed bed for high‐efficiency selective oxidation of n ‐butane

A Good Performance Vpo Catalyst for Partial Oxidation of N-Butane to Maleic Anhydride

The Novel and Highly Selective Fumed Silica-Supported VPO for Partial Oxidation of N-Butane to Maleic Anhydride

Carbonaceous Deposition on Mo/HMCM-22 Catalysts for Methane Aromatization: A TP Technique Investigation

A Study on VPO Specimen Supported on Aluminum-Containing MCM-41 for Partial Oxidation of n-Butane to MA

Mechanistic Study of Propylene Oxidation over a Bi–molybdate Catalyst by in Situ DRIFTS and Probe Molecules

Microcalorimetric Adsorption Characterizations of Supported Vanadia Catalysts for the Selective Oxidation of Propylene to Acetone

Increasing maleic anhydride selectivity for n-butane oxidation by Y-modified VPO catalysts

Revealing the mechanism of VO x /Ti 3 AlC 2 for the dehydrogenation of propane

Effect of carbon dioxide on the reaction performance of oxidative dehydrogenation of n-butane over V-Mg-O catalyst