Abstract:This paper proposes a cross recurrence plot(CRP) based method which is a useful tool to detect the subtle nonlinear changes in time-series data to monitor the drop of the transformer core clamping pressure.Firstly,distance threshold e of the recurrence plot is chosen empirically according to the RP dynamical structures of the core vibration signals.Then the multivariate RP/CRPs which are formed between the core vibration signals under good conditions and loose conditions are constructed from the data sampled from various measuring locations on the core to check the global loose condition,while univariate RP/CRPs are constructed from the data sampled at every solitary measuring location to view the local loose conditions.Finally,four recurrence qualification analysis(RQA) measures based on diagonal lines are derived from the RP/CRPs generated above to measure the change of the core pressure.Experiments were performed on two different transformers whose clamping forces were controlled to decrease gradually in the laboratory and factory;the vibration data of the transformers' core corresponding to pressures of different level were also recorded.The results of the method which was applied to the experimental data show three of four RQA metrics were monotonically decreasing along with the clamping pressure,in which recurrence rate was especially good.The proposed method is valid to detect the drop of the core pressure and reflect the changes of the core mechanical structure effectively.

Application of CRP to Detection of Transformer Core Clamping Force Drop

Detection of transformer cores looseness using RQA

Application of kurtosis in on line detection of transformer iron core looseness

Detection Method for Jam Fault in Manipulative Mechanism of Steam Turbine Regulating System

HHT Based Method for Monitoring Core Clamping Pressure of Power Transformers

Research on On-Load Current Method for Detecting Fault of Transformer Core Based on the Vibration Analysis Method

APPLICATION OF ON-LOAD CURRENT METHOD IN MONITORING THE CONDITION OF TRANSFORMER'S CORE BASED ON THE VIBRATION ANALYSIS METHOD

RLS-Based Algorithm for Detecting Partial Demagnetization under Both Stationary and Nonstationary Conditions

Study Of On-Line Monitoring Method Of Partial Discharge For Power Transformers Based On Rfct And Microstrip Antenna

A Novel Residual Magnetism Detection Method of Power Transformer Cores Based on Magnetization Time

Application of Vibration Method on Monitoring the Winding and Core Condition of Transformer

Detecting Measurement Error Drifts of a Capacitor Voltage Transformer on Line and Its Field Application

An NPE-PCA-based Detection Method of Distribution Transformer Closing Surge Waveform

Vibration Monitoring of On-load Tap-changer by Resonance-based Sparse Signal Decomposition

Research on Extraction Technique of Transformer Core Fundamental Frequency Vibration Based on OLCM

On-line diagnosis for a transformer winding's stateunder short-circuit shock

On-site Application of Partial Discharge Detection of Transformer Using Very Wide Bandwidth Pulse Current Method

Mechanical Condition Detection of On-Load Tap-Changer in Converter Transformer Based on Narrowband Noise Assisted Multivariate Empirical Mode Decomposition Algorithm

The Vibration Measuring System for Monitoring Core and Winding Condition of Power Transformer

A Review of Research Progress on Residual Magnetism Detection Methods for Power Transformer Cores

Research on Vibration Signal of Transformer Tank Surface under No-Load Condition