Heavy-duty Die Forging Hydraulic Press Moving Finite Element Analysis

曹兴强,黄明辉,湛利华,彭伟波

DOI: https://doi.org/10.3969/j.issn.1671-3133.2009.05.027

2009-01-01

Abstract:A three-dimension finite element model of the moving beam is built based on the Marc software platform.It is found that the stiffness of the beam is inadequate,which result in two gaps between the central beams of the moving beam;there are two weak strength sections where existing in the tie rod cylindrical hole and chamfering nearby the perforation cylinder.Aimed at the gags between the central beams,two modified schemes are put forward:the first scheme lays some stiffness rib at the central hole and perforation cylinder side of the central beams,another scheme is adjusting the relative stiffness between the central beams and spacer plates group by changing the height ratio between the central beams and spacer plates group.Analysis results show both of the two schemes can improve the stiffness of the central beams,when the stiffness rib are placed,maximal displacement of the central beam decrease 24.2 percent,relative deflection decrease 30.7 percent,maximal distance of the gap decrease 54.5%percent;while the height of spacer plates group increase 30.7 percent,maximal displacement of the central beam decrease 33.4 percent,relative deflection decrease 50.5percent,maximal distance of the gap decrease 64.9%percent.The analysis results will contribute some reference value to the heavy-duty hydraulic press design.