Abstract:Determination of the distribution of a generated acoustic field is valuable for studying ultrasonic transducers, including providing the guidance for transducer design and the basis for analyzing their performance, etc. A method calculating the acoustic field based on laser-measured vibration velocities on the ultrasonic transducer surface is proposed in this paper. Without knowing the inner structure of the transducer, the acoustic field outside it can be calculated by solving the governing partial differential equation (PDE) of the field based on the specified boundary conditions (BCs). In our study, the BC on the transducer surface, i.e. the distribution of the vibration velocity on the surface, is accurately determined by laser scanning measurement of discrete points and follows a data fitting computation. In addition, to ensure the calculation accuracy for the whole field even in an inhomogeneous medium, a finite element method is used to solve the governing PDE based on the mixed BCs, including the discretely measured velocity data and other specified BCs. The method is firstly validated on numerical piezoelectric transducer models. The acoustic pressure distributions generated by a transducer operating in an homogeneous and inhomogeneous medium, respectively, are both calculated by the proposed method and compared with the results from other existing methods. Then, the method is further experimentally validated with two actual ultrasonic transducers used for flow measurement in our lab. The amplitude change of the output voltage signal from the receiver transducer due to changing the relative position of the two transducers is calculated by the proposed method and compared with the experimental data. This method can also provide the basis for complex multi-physical coupling computations where the effect of the acoustic field should be taken into account.

Structural Design of a New-Type Underwater Acoustic Projectile Transducer

Research and Fabrication of High-Frequency Broadband and Omnidirectional Transmitting Transducer

Design simulation and analysis of deep-sea transducer

Structural Design and Optimization of Low-Frequency High-Power Electromagnetic Transducer

Design of Ultrasonic Transducer Structure for Underwater Wireless Power Transfer System

Structural Optimization and Performance of a Low-Frequency Double-Shell Type-IV Flexural Hydroacoustic Transducer

Study on Characteristics of a New Type of Electro-Thermo-Acoustic Transducer

Design of Piezoelectric Acoustic Transducers for Underwater Applications

3-D Finite Element Analysis and Optimum Design of Electromagnetic Acoustic Transducers

A Low-Frequency Unidirectional Underwater Acoustic Transducer

Design of surface wave electromagnetic acoustic transtucers

Finite Element and Experimental Study of Composite and 1-D Array Transducers

Calculation of Acoustic Field Based on Laser-Measured Vibration Velocities on Ultrasonic Transducer Surface

Receiving Performance Analysis and Optimal Design of Surface Wave Electromagnetic Acoustic Transducers in Nonferromagnetic Materials

Novel multi-layer-composites design for ultrasonic transducer applications

Research and Fabrication of Broadband Ring Flextensional Underwater Transducer

Modeling and Experiment of a Small Size Dual Mode Transducer for Underwater Acoustic Communication and Detection

Design of Ultrasonic Transducer with a Quarter Wavelength Composite Exponential Horn

Design and Experimental Validation of a Broadband Multi-Modal Coupled Capsule-Shaped Transducer for Underwater Acoustics

Design and Fabrication of an Underwater Transducer Based on the Shear Vibration Mode and Trapezoid Transition Layer

Finite Element Calculation with Experimental Verification for a Free-Flooded Transducer Based on Fluid Cavity Structure