Abstract:In this study, a thermo-mechanical finite element model was developed to investigate the thermal deformation during a stamping process of an automotive body part. The stamping process was decomposed into the 6 sub-steps to reflect the physical boundary conditions found in an actual stamping equipment. The temperature distributions of the actual stamping process were measured by two thermography cameras. The developed numerical procedure was then validated against the measured temperature distributions. Due to the limited accessibility to the actual equipment and high reflectivity of the involved material, the reflectivity index for the thermal imaging device (i.e., emissivity) was experimentally determined. A sample specimen made of the same material with the die material was built. The thermocouples were placed underneath the specimen surface through holes and used to directly measure the surface temperature distribution. The emissivity for the sample specimen was then determined by comparing the temperature measured by the thermocouples to the temperature measured by the thermographic camera. When the lubrication oils were spread on the sample specimen, the emissivity was set to a value 0.7. The thermal images were corrected based on the emissivity experimentally obtained and used to validate the finite element model simulation for the stamping process. With the validated finite element model, the investigation on the variation in the temperature and stress during each sub-step was performed. With the zero thermal expansion rate, the pure thermal effect on the temperature distribution was simulated. The pure thermal deformation in the Blank (i.e., target surface) was similar to the spring back distance after the blank was released from the molds. During the stamping process, the heat generation was obtained due to either friction between surfaces and plastic deformation of the target surface. We found that the plastic deformation played a critical role in the final temperature rise.

STUDY ON TEMPERATURE FIELD OF CONTINUOUS EXTRUSION FORMING PROCESS

Continuous Casting Mould for Square Steel Billet Optimised by Solidification Shrinkage Simulation

Research on the Mechanism and Processability of Roll Forming

Numerical Simulation and Process Optimization of Internal Thread Cold Extrusion Process

Hot Formability Study of Cr5 Alloy Steel by Integration of FEM and 3D Processing Maps

Numerical Simulation of Canned Hot-Extrusion Process of Mo Powder

Temperature-Dependent modelling of tension, in-Plane shear, and bending behaviour in non-isothermal thermo-Stamping process simulation of unidirectional UHMWPE fibre reinforced thermoplastic TPU composites

Numerical modeling of the thermal deformation during stamping process of an automotive body part

Finite Element Simulation of Extrusion Process of TC4 Titanium Alloy Profile

FEM model optimization study of mechanical properties and material selection in stamping process

Analysis of heat transfer and thermal stress in continuous casting with mechanical reduction

Numerical Simulation of the Thermo-Mechanical Process for Beam Blank Continuous Casting

Simulation of the Technological Process of Manufacturing Continuous Metal Products on a Casting and Forging Module with a New Modification

Application of Modeling and Simulation of Thermal Stress in Solidification Process of a Heavy Steel Casting

Modeling and Simulation of Heat Transfer in Loaded Continuous Heat Treatment Furnace

NONLINEAR THREE-DIMENSIONAL SIMULATION FOR HOT CONTINUOUS ROLLING OF STRIP STEEL

The Development of a Continuous Constitutive Model for Thin-Shell Components with A Sharp Change in the Property at Welded Joints

Numerical Simulation of 6061 Aluminum Alloys during the Semi-Solid Backward Extrusion

Constitutive modeling and analysis on high-temperature flow behavior of 25 steel

Electrical-thermal-mechanical coupled modeling and simulation on deformation behaviors of Ti6554 alloy in electrically-assisted micro-tension

Research on incremental forming simulation based on an improved constitutive model