Abstract:The characteristics of the materials used in early buildings in China have led to a large proportion of discarded red bricks among the construction waste generated by demolishing abandoned buildings. The application of red brick aggregate with a particle size ≤5 mm and red brick powder with particle size 0.125~0.75 mm (referred to as recycled brick powder) was studied in this study after the crushing of waste red brick in road structures. The research results will provide a theoretical basis for the whole-grain recycling of waste red brick aggregate. The aggregate of red brick with a particle size smaller than 2 mm was mixed with different amounts of cement soil and fiber to prepare a cement-stable binder for the sub-base material. The recycled brick powder of 0.125~0.75 mm was used to replace the quartz sand with different substitution rates. As pavement materials, different amounts of fiber were used to prepare fiber-reinforced recycled-brick-powder cementitious composites. The optimal mixing ratio of the two materials was evaluated from the mechanical properties. The results showed that the optimal mixing ratio of the cement-stable binder was as follows: waste-red-brick-aggregate content was 50%, cement content was 4%, and fiber content was 0.2%. The optimum ratio of fiber-reinforced recycled-brick-powder cementitious composites was determined to be as follows: the replacement rate of recycled brick powder is 25%, and the content of PVA fiber is 1%. The regression analysis was used to fit the equations between the fiber content and the 7d unconfined compressive strength and the tensile strength of the cement-stabilized binder for different red-brick-aggregate admixtures at 4% cement content. A scanning electron microscope was used to observe the failure modes of the fiber. The influence of failure modes, such as pulling out, fracture, and plastic deformation, on the mechanical properties was expounded.

Preparation and properties of recycled rapid repair concrete

Study on the Effect of Fly Ash and Polycarboxylic Acid Water Reducer on the Properties of Recycled Concrete

Study on preparation technology of recycled aggregate rapid repair concrete

State-of-the-art report of recycled aggregate concrete and rapid repair concrete

Recycled Concrete Intensified by Nano-materials

Properties of Recycled Aggregate Concrete with Different Water Control Methods

Intensified Test Research on the Influence of Polypropylene Fiber & Silica Fume on Recycled Concrete

Road Performance Investigation on Fiber-Reinforced Recycled Cement Base Material

Study on Mechanical and Shrinkage Properties of High Belite Sulphoaluminate Cement-Based Green Recycled Aggregate Concrete

Study on Preparation of High Early Strength Recycled Aggregate Concrete

PROPERTIES AND MICROSTRUCTURE OF HIGH PERFORMANCE RECYCLED AGGREGATE CONCRETE

Compressive Strength, Permeability, and Abrasion Resistance of Pervious Concrete Incorporating Recycled Aggregate

Experimental Study on High Performance Recycled Concrete

Study On Properities Of Recycled Concrete Aggregate And Influence Of It On Properities Of Concrete

Preparation of High-Ductility Cement-Calcined Coal-Gangue-Powder-Composite-Based Rapid Repair Material

Study on the Effect of Recycled Coarse Aggregate on the Shrinkage Performance of Green Recycled Concrete

Rheological and early hydration of cementitious material containing recycled concrete powders collected from recycled aggregates

Preparation and Properties of Natural Bamboo Fiber-Reinforced Recycled Aggregate Concrete

Study on Durability of Recycled Large Aggregate Concrete

Assessment of bonding, durability, and low-temperature performance of cement-based rapid patching materials for pavement repair

Experimental Study on the Mechanical Properties and Permeability of Cement-Stabilized Permeable Recycle Aggregate Materials