Abstract:An experimental research was conducted on seismic behavior of stiffened thin steel plate shear walls (SPSWs) considering the effect of vertical load on frame column. Two full-scale rectangular concrete-filled steel tube columns-stiffened thin steel plate shear specimens were tested under low-cycle reverse load. The design of specimens considers two cases of vertical stiffeners with equal spacing and variable spacing. The test results show that the specimens have good ductility and energy consumption capacity when the frame columns are subjected to high axial pressure. The ultimate drift angle of the specimens reaches 1/30. The plastic deformation of the specimens is mainly manifested as the out-of-plane buckling, which satisfies the design concept of “strong column and weak beam”. The arrangement of the stiffeners has no obvious influence on the seismic performance of the specimens. The nonlinear finite element method is further used to study the influence of initial defects and axial compression ratio on the lateral resistance performance of the specimen. The analysis results show that the initial defect distribution mode of the wall and the out-of-plane deflection amplitude have little effect on the pushover curve of the specimens. When the axial compression ratio of the frame column is greater than 0.7, the bearing capacity and deformation capacity of the specimens are reduced. Based on the shear control failure characteristics of the specimens, the calculation method of the specimen’s shear capacity is given. The calculated value is in good agreement with the finite element simulation value, and it is conservative than the experimental value.

Elastic-plastic Analysic of Short-leg Shear Wall Structure with Simulative Static Test

STUDY OF ELASTIC-PLASTIC DESIGN TECHNOLOGY OF UNSTIFFENED STEEL PLATE SHEAR WALL

STIFFENER STIFFNESS AND ELASTIC BUCKLING STRESS OF STEEL PLATE SHEAR WALL

Experimental study and numerical simulation of seismic performance of stiffened thin steel plate shear walls considering the effect of vertical load on frame column

Finite Element Simulative Test of L-shaped Shot-leg Shear Wall

FINITE ELEMENT SIMULATION ON THE ENTIRE MECHANICAL PERFORMANCE OF T-SHAPED SHORT-LEG CONCRETE SHEAR WALLS UNDER STATIC LOADING FROM ELASTIC TO COLLAPSE STAGES

Simulative Test on Static Property of Shot-leg Shear Wall

ELASTIC STABILITY OF STEEL PLATE SHEAR WALL WITH CROSS STIFFENERS IN SHEAR

Simulative Analysis of Load Capacity on High-Level Short-Leg Shear Wall

Analysis and Optimization of Deformation Capacity on High-Level Short-Leg Shear Wall

ANALYSIS ON ECCENTRIC COMPRESSION OF SHORT- LEG MASONRY SHEAR WALL

Numerical Simulation and Shear Capacity Study of a New Double-Steel-Plate Shear Wall

Experimental study and FEM analysis on seismic behavior of a three-storied structural wall

Nonlinear FEM Analysis on RC Structural Wall with Large Eccentric Openings

Nonlinear Finite-Element Analysis of Double-Skin Steel-Concrete Composite Shear Wall Structures

Comparative Analysis of Load Capacity on Three Kinds T-Shaped Short-Leg Shear Walls

Analysis on Reinforce Concrete Sandwich Wall-Panel Using Nonlinear Finite Element Method

Elasto-Plastic Analysis Of Reinforced Concrete Shear Wall With Openings Using A Macro Model

Comparison and Optimization of Influence of Reinforcement Ratio on Deformation and Ductility of Short-leg Shear Wall

Nonlinear finite element analysis of prefabricated hollow-core reinforced concrete shear walls

Seismic Analysis and Design of Composite Shear Wall with Stiffened Steel Plate and Infilled Concrete