Structural Design for Common Satellite Retroreflector Array

周辉,李松,郑国兴

DOI: https://doi.org/10.3969/j.issn.1007-2276.2009.04.025

2009-01-01

Infrared and Laser Engineering

Abstract:As the cooperative target of laser ranging system,the satellite retroreflector array is usually used to improve the energy of reflected beam within wide observed range.Two important performance parameters of retroreflector array including photoelectron number of received signal and correction error of center-of-mass were determined directly by its structure form.To design the structural parameters of common retroreflector array optimally,the photoelectron number of received signal would be maximized and correction error of center-of-mass would be minimized during the observation range.Based on operational principle for laser ranger with cooperative target,the mathematical expressions of the photoelectron number of received signal and correction error of center-of-mass were deduced.In terms of the goal of optimization,the way of structural design for common satellite retroreflector array was given.Take ADEOS-Ⅱ satellite retroreflector array in Japan as example,its structural parameters were numerically calculated:the number of retroreflector was 9,the structural inclination and azimuth angle were 50 ° and 45° respectively,sphere radius was approximately 85.7 mm.The designed result is consistent with the parameters of ADEOS-Ⅱ retroreflector array,which verifies the correctness of design theory in this paper.