Abstract:Achieving high data rate with simple system configuration and low power consumption is of great interest in short-reach intensity-modulation direct-detection (IM-DD) fiber links for future datacenter networks, business local area networks and so forth. For external modulation-based IM-DD, recently remarkable modulator performance has been achieved in terms of 3dB bandwidth, exploiting different materials/platforms. However, due to the relatively-high RF-to-RF (or end-to-end) signal loss, optical amplifiers (OA) and/or RF amplifiers (RFA) were typically needed for IM-DD links, which increases the complexity and power dissipation. In this work, we present a more comprehensive figure of merit (FoM) for modulator (and link) design, namely “slope efficiency (SLE)”, which takes into account not only the bandwidth but also the half-wave voltage and the RF/optical waveguide losses, and can provide a guiding principle of the modulator design toward lower RF-to-RF signal loss. With a high-SLE modulator, both OA and RFA can be omitted even when supporting broadband signals with CMOS-level driving voltages. We theoretically investigate the impact of modulators with different technology and SLE on the IM-DD pulse amplitude modulation (PAM) link. Next, we report a series of PAM transmission experiments with a high-SLE Lithium Niobate intensity modulator prototype, which enables sub-1Vpp driving, up-to-432Gb/s PAM transmission over up-to-600m single-mode fiber in C-band with OA&RFA-free reception and low digital signal processing (DSP) complexity. For instance, for 384Gb/s PAM8 over 300m, the transmitter was DSP-free while a symbol-spaced decision-feedback equalizer (DFE) with 61 feedforward taps and 1 feedback tap was sufficient for the receiver considering 16.7% hard-decision (HD)-FEC. Furthermore, we experimentally show that the high-SLE modulator supports ultra-wide fiber transmission bands (O-, S-, C- and L-band).

Applications of High-Saturation-current Photodiode in the RoF Links with Low Noise Figure and High Gain

Optical Amplification-Free High Baudrate Links for Intra-Data Center Communications

Ultra-flat and Broadband Two-Pump Optical Parametric Amplifiers Using a Single-Section Highly Nonlinear Fiber

Optically synchronized unidirectional optical amplifier-based coherent optical fiber links

Experimental study of two-stage erbium doped fiber amplifiers pumped by 980 nm and 1480nm LD

Modulation Depth Optimization of High-Power Photodiodes-Driven-Antennas Link

9.14-Mbps 64-PPM UWOC system based on a directly modulated MOPA with pre-pulse shaping and a high-sensitivity PMT with analog demodulation

High-Speed EAM Integrated Device Based Microwave Fiber-Optic Links

High-speed Optoelectronic Devices

Two-stage Erbium Doped Fiber Optical Power Limiting Amplifiers with Incorporated Differential Loss Loop

High-Power, Wide-Bandwidth Modified Uni-Traveling-Carrier Photodiodes with an Optimized Depletion Region

Advanced digital signal processing for short-haul and access network

High-power MUTC Photodiode Module for Photonics-assisted Beyond 100 Gb/s Wireless Sub-THz Communications in the F-band

Ultra-Low Noise Figure in Optical Fiber Amplifier by Tailoring the Mode Field Profile of Erbium-Doped Fiber

Bandwidth Optimization and Fabrication of High-Power MUTC-PD

A Microwave Photonics Equalizer for Overcoming Dispersion-Induced Distortions on Wideband Signals in Radio-Over-Fiber Links

Low Pump Power Co-Fiber Remotely Pumped EDFA Used in DWDM Systems with Ultra-Long Fiber Span

High-Speed Low-Complexity Optical PAM Links With a High-Slope-Efficiency Optical Modulator: Analysis and Demonstration

Comparative study of single pump all optical fiber amplifiers (POAs) with ultra wide band and high gain fiber optic parametric amplifiers in highly nonlinear fibers

Performance Analysis and Comparison of Bi-directionally Pumped Raman Amplifiers

Study on the properties of high speed optical fiber communication systems