Abstract:Using an inert, immiscible organic component as the purging gas is an innovative technology in the CO2 stripping process. It allows stripping at a lower temperature and overcomes the inherent problem of high energy consumption in steam-based CO2 stripping processes. This work focused on developing a novel, direct non-aqueous gas stripping process and exploiting its potential for energy saving through experiments. An elaborate pre-screening of carrier gases was conducted through hydrocarbon, alcohols, aldehydes, ketones, and their isomers, etc. Pentane, hexane, and cyclohexane were selected as the carrier candidates for their good immiscibility with water/amine, low vaporization energy, mild condensation conditions, and low toxicity. The effects of carrier gas category, carrier gas flow rate, and rich solvent feeding temperature on the stripping performance were investigated. Pentane was found to be the superior carrier gas due to its low heat of vaporization, high regeneration rate, and low energy requirement. A unique phenomenon of water evaporation from the solvent was discovered in the organic gas stripping process, providing a promising approach to break the gas-liquid interface for enhanced diffusion kinetics. The feasibility of low temperature CO2 stripping was analyzed by varying the rich solvent feeding temperature (70-100 degrees C). With pentane as the stripping gas, it was interesting to find an optimum rich feed temperature lower than 90 degrees C, indicating great potential for a reduction in the overall energy requirement. Under the optimal conditions, the energy consumption during CO2 regeneration, using pentane as the carrier gas, was 2.38 Gift CO2, 38.8% lower than that of the conventional stripping process. Furthermore, parasitic issues, such as water loss and solvent loss, were discussed. An improved direct non-aqueous gas stripping process with two-stage compression was used to tackle the carrier gas recovery problem. The simulation results show that more than 98% of the carrier gas can be recovered through preliminary separation approaches. (C) 2017 Elsevier Ltd. All rights reserved.

Optimized Process Configuration for CO2 Recovery from Crude Synthesis Gas Via a Rectisol Wash Process

Reconfiguration of Acid Gas Removal Process Matching the Integration of Coal Chemical Industry with Green Hydrogen

Thermodynamic calculations for reactive sorption enhanced reforming of C2/C3 light hydrocarbons

Process optimization of CO2membrane and cryogenic hybrid separation

Liquid-phase CO2 Hydrogenation to Methanol Synthesis: Solvent Screening, Process Design and Techno-Economic Evaluation

Development of a Full CO2 Capture Process Based on the Rectisol Wash Technology

Combined Energy Consumption And Co2 Capture Management: Improved Acid Gas Removal Process Integrated With Co2 Liquefaction

Conceptual Design, Optimization and Thermodynamic Analysis of a CO2 Capture Process Based on Rectisol

Advanced Rectisol wash equipment incorporating syngas liquefaction and methane recovery for enhanced energy management

Thermodynamic Analysis of a Semi-Lean Solution Process for Energy Saving Via Rectisol Wash Technology

Solvent Regeneration by Novel Direct Non-Aqueous Gas Stripping Process for Post-Combustion CO2 Capture

High Yield of CO and Synchronous S Recovery from the Conversion of CO2 and H2S in Natural Gas Based on a Novel Electrochemical Reactor

Design and Optimization of VOC Control Process for Tail Gas in Rectisol Unit Based on Steady State and Dynamic Simulation

A New Process of Solveing Corrosion Problem of Refined Liquefied Gas

Analysis and optimization for chemical absorption of H2S/CO2 system: Applied in a multiple gas feeds sweetening process

Process Optimization of Heat-Integrated Extractive Dividing-Wall Columns for Energy-Saving Separation of CO2 and Hydrocarbons

High Yield of CO and Synchronous S Recovery from the Conversion of CO 2 and H 2 S in Natural Gas Based on a Novel Electrochemical Reactor

Process Integration and Operation Optimization of Absorption-Stabilization System

Elevated Temperature Pressure Swing Adsorption Process for Reactive Separation of CO/CO2 in H2-rich Gas

Simultaneously enhancing H2 recovery and CO2 captured pressure during the hydrogen purification process of medium-temperature shifting gas by coupled wet CO2 separation-PSA technology: From laboratory to industrial scale test

Application of double side-draw stripper process in coal-gasification wastewater treatment