Abstract:Determination of the magnetic field around an electromagnetic velocity probe is a key work for the dry calibration of the probe. In the paper, a novel divisionally analytical reconstruction approach to determine the magnetic field is introduced. It is especially suitable to be used in the dry calibration due to following advantages: no numerous measurements needed, unnecessary to know the inner magnetic exciting structure of the probe, high accuracy and convenient for further calculations. It is a measurement and calculation joint approach, in which the magnetic field is calculated from the measured boundary conditions through solving a Laplace’s equation of magnetic scalar potential. To obtain an analytical solution of the Laplace’s equation, the complex calculation geometry around the probe is divided into two simple ones using an auxiliary surface, and then the Laplace’s equation in the each generated geometry is analytically solved through a method of separation of variables. The divisionally analytical solution is pre-requisite since a pure analytical solution can bring convenience for further calculations in the dry calibration and such a solution is still lacked due to the complexity of the calculation geometry. A magnetic scanning device used to measure the distributions of the normal component of magnetic field on the surface of probe and the auxiliary surface is also introduced. The measured data provide the required boundary conditions for the determination of the magnetic field. Finally, the novel approach is validated through reconstructing the magnetic field around an actual electromagnetic velocity probe and comparing the results with the experimentally measured data.

High-Resolution 2D Magnetic Field Measurement of Magnetic Reconnection Using Printed-Circuit Board Coils

Development of High-resolution Two-dimensional Magnetic Field Measurement System by Use of Printed-circuit Technology

Divisionally Analytical Reconstruction of the Magnetic Field Around an Electromagnetic Velocity Probe

Magnetic flux array for spontaneous magnetic reconnection experiments

Recent Progress in High Resolution 2D Imaging Measurements of Reconnection Heating During Merging Plasma Startup in TS-3

Dual-Components Magnetic Probe for Electromagnetic Interference Measurement

A Wideband and High Sensitivity Probe Design for Near-Field Scanning

An octahedral Mach B-dot probe for 3D flows and magnetic fields in the edge of reversed field pinches

Local dynamic responses of magnetic reconnection to three-dimensional perturbations in a laboratory plasma

Low-βmagnetic Reconnection Driven by the Intense Lasers with a Double-Turn Capacitor-Coil

Development of a Thin High-Frequency and High-Precision Magnetic Probe Array in Sino-United Spherical Tokamak

Quadrupolar Density Structures in Driven Magnetic Reconnection Experiments with a Guide Field

Experimental Study of Two-Fluid Effect During Magnetic Reconnection in the UTST Merging Experiment

A method for determining the locations and configurations of magnetic reconnection within three-dimensional turbulent plasmas

Laboratory Observation of Plasmoid-Dominated Magnetic Reconnection in Hybrid Collisional-Collisionless Regime

A High-Frequency and High Spatial Resolution Probe Design for EMI Prediction

High resolution magnetic field imaging probe with two rows of TMR sensors for small defects inspection

The Eddy Current Probe Array for Keda Torus Experiment.

Design, construction, and calibration of a three-axis, high-frequency magnetic probe (B-dot probe) as a diagnostic for exploding plasmas

Identification of Active Magnetic Reconnection Using Magnetic Flux Transport in Plasma Turbulence

A Method for Determining the Locations and Configurations of Magnetic Reconnection within 3D Turbulent Plasmas