Abstract:Cu(In,Ga)Se2 (CIGSe)-based solar cells are promising candidates for efficient sunlight harvesting. However, their complex composition and microstructure can change under operation conditions, for instance heating from sun light illumination can lead to a degradation in performance. Here, we investigate the thermally-induced degradation processes in a set of CIGSe-based solar cells that were annealed at temperatures between 150C and 300C. Using correlative atom probe tomography (APT)/transmission electron microscope (TEM), we found that the buffer-absorber interface is not sharp but consists of an interfacial zone (2 - 6.5 nm wide) where a gradient of constituent elements belonging to the CdS buffer and CIGSe absorber appears. An enhanced short-range Cd in-diffusion inside the CIGSe was observed whenever a low Ga/(Ga+In) ratio occurred at the interface. This might indicate the presence of Ga vacancies as a channeling defect for Cd in-diffusion inside the CIGSe layer leading to a buried pn-homojunction. We evidence that a considerable amount of Cd is found inside the CIGSe layer at annealing temperatures higher than 150C. Further investigations of the elemental redistribution inside the CIGSe layer combined with C-V measurements support the formation of CdCu donor like defects deep inside the p-type CIGSe which lead to a strong compensation of the CIGSe layer and hence to strong deterioration of cell efficiency at annealing temperatures higher than 200C. Hence, understanding the degradation processes in Cu(In,Ga)Se2 (CIGSe)-based solar cells opens new opportunities for further improvement of the long-term device performance.

Grain boundary passivation by CdCl 2 treatment in CdTe solar cells revealed by Kelvin probe force microscopy

Two-stage annealing-induced secondary grain growth for enhanced efficiency in CdTe solar cells on flexible polyimide foils

Enhanced electrical properties at boundaries including twin boundaries of polycrystalline CdTe thin-film solar cells

High-efficiency CdTe-based Thin-Film Solar Cells with Unltrathin CdS:O Window Layer and Processes with Post Annealing

Grain Boundaries Induce Significant Decrease in Lattice Thermal Conductivity of CdTe

Copassivation of Polycrystalline CdTe Absorber by CuCl Thin Films for CdTe Solar Cells

Cathodoluminescence spectrum imaging analysis of CdTe thin-film bevels

Effects of Oxidation and CdCl2 Treatment on the Electronic Properties of CdTe Polycrystalline Films

Enhanced performance CdZnTe single crystal with few surface damages via solution based annealing

Grain boundary strain localization in CdTe solar cell revealed by Scanning 3D X-ray diffraction microscopy

Strategy for Performance Enhancement of Cd1-XZnXTe/CdS Core/shell Quantum Dot Sensitized Solar Cells Through Band Adjustment

Buried junction and efficient carrier separation in CdSexTe1−x/CdTe solar cells

CdTe thin film solar cells with a SnTe buffer layer in back contact

Grain boundary strain localization in a CdTe solar cell revealed by Scanning 3D X-ray diffraction microscopy

Effects of Postdeposition Treatments on Surfaces of Cdte/Cds Solar Cells

Self-passivation Rule and Structure of CdTe Σ3 (112) Grain Boundaries

Effect of Cd diffusion on the electrical properties of the Cu(In,Ga)Se2 thin-film solar cell

Microregion Characterization of Grain Boundary Defects and Electron Capture of CsPbI2Br Perovskite

Interface Formation between CdS and Alkali Postdeposition-Treated Cu(In,Ga)Se2 Thin-Film Solar Cell Absorbers-Key To Understanding the Efficiency Gain

Back-surface electric field passivation of CdTe solar cells using sputter-deposited CdSe

Effect of CdCl2 Annealing Treatment on Thin CdS Films Prepared by Chemical Bath Deposition