Abstract:Summary form only given. Capillary discharge plasmas have been widely used as electrothermal chemical (ETC) launch devices, fusion reactor pellet injectors and high heat flux sources for material studies. In the electro thermal chemical launcher, the mechanisms of the plasma-propellant interaction are critical, with many factors being of potential importance. In particular, the role of plasma radiation is disputed. We will report the effect of three different metal ions and radiation in the capillary discharge plasma on the plasma-propellant interactions. Conventionally, a capillary initiated by a metal wire of about 2 mg and with an ablative liner material (e.g. polyethylene) is used as the plasma generator. The plasma is mainly composed of CO, H + , C, etc. The proportion of metal ions was negligible. We have designed a new capillary discharge plasma generator with different metal powders of higher weight as the initiators. The performance of the new generator is compared with the traditional one through an open-air test. A spectrometer and ICCD were used to measure the surface temperature of the propellants while a CCD was used to visualize the plasma jet. The combustion tests were conducted in a transparent closed vessel, making it possible to measure the plasma parameters at the propellant surface and observe the combustion process in the closed vessel. A fused silica window was placed between the plasma and propellants to ensure that the propellant could only be affected by plasma radiation. The burning rate and the p-t curve were obtained in the tests and the combustion products were analyzed by a mass spectrometer. Interrupted burning tests were also carried out to acquire information about the surface of the propellants at different burning stages. In order to perform accurate modeling of the plasma-propellant interaction, we have also developed a two-dimensional time-dependent capillary discharge model based on a modified ablation model. In our model, special attention is paid to the radial distribution of the capillary discharge plasma characteristics. To investigate the factors that influence the radial distribution, the radial transport of the ablation products is taken into consideration. Further, the competition between the ablation and deposition process with time in the capillary discharge is also studied. The aim of our study are to provide results that will assist the design of new propellants and new plasma generators for the ETC launcher.

The Effect of the Length to Diameter Ratio on Capillary Discharge Plasmas

Investigation into Geometric Effect in Capillary Discharge Plasma Generator Using an Improved Ablation Model

Generation of Large-volume Plasma Under Low Air-pressure and Study of Its Electrical Characteristics

Discharge Electrode Configuration Effects on the Performance of a Plasma Sparker

Current–voltage Characteristics of Hydrogen DC Plasma Torches with Different Sizes in an External Axial Magnetic Field

Influence Factor Analysis on Jet Length of Atmospheric Pressure Argon Plasma Jets

Static Electric Field Intensity Calculation of Two Kinds of Electrode Structure Plasma Generator

Investigation of pulse plasma reactor discharge characteristics

Influence of structural parameters of needle-ring electrode on the length of argon plasma jet under atmospheric pressure

Roles of Metal Ions and Plasma Radiation in the Interactions Between A Capillary Discharge Plasma and Propellants

Investigation On Spurt Length Of Atmospheric-Pressure Plasma Jets

Effects of Gas Flow Rate on the Length of Atmospheric Pressure Nonequilibrium Plasma Jets

Numerical study on the effects of discharge parameters on vacuum arc plasma

Influence of plasma size on discharge extreme ultraviolet source

The Influence of Discharge Capillary Size, Distance, and Gas Composition on the Non-Equilibrium State of Microplasma

Effect of Dielectric Wall Temperature on Plasma Plume in an Argon Atmospheric Pressure Discharge

Effect of Plasma Density on Discharge Produced Plasma Extreme Ultraviolet Source

Design of a Low Temperature Plasma Generator

Discharge Characteristics of Fusion Plasma Jet Array and Its Influencing Factors

Influence of the Inner Diameters of Capillary on the Z‐Pinch Plasma of the Capillary Discharge Soft x‐ray Laser

Effect of the Grounded Electrode on Cold Ar Atmospheric Pressure Plasma Jet Generated with a Simple DBD Configuration