Abstract:A new solid-contact ion-selective electrode (ISE) sensitive to lead (II) ions, obtained by modifying a polymer membrane with a nanocomposite of carbon nanofibers and an ionic liquid 1-hexyl-3-methylimidazolium hexafluorophosphate, is presented. Electrodes with a different amount of nanocomposite in the membrane (0–9% w/w), in which a platinum wire or a glassy carbon electrode was used as an internal electrode, were tested. Potentiometric and electrochemical impedance spectroscopy measurements were carried out to determine the effect of the ion-sensitive membrane modification on the analytical and electrical parameters of the ion-selective electrode. It was found that the addition of the nanocomposite causes beneficial changes in the properties of the membrane, i.e., a decrease in resistance and an increase in capacitance and hydrophobicity. As a result, the electrodes with the modified membrane were characterized by a lower limit of detection, a wider measuring range and better selectivity compared to the unmodified electrode. Moreover, a significant improvement in the stability and reversibility of the electrode potential was observed, and additionally, they were resistant to changes in the redox potential of the sample. The best parameters were shown by the electrode obtained with the use of a platinum wire as the inner electrode with a membrane containing 6% of the nanocomposite. The electrode exhibited a Nernstian response to lead ions over a wide concentration range, 1.0 × 10−8–1.0 × 10−2 mol L−1, with a slope of 31.5 mV/decade and detection limit of 6.0 × 10−9 mol L−1. In addition, the proposed sensor showed very good long term stability and worked properly 4 months after its preparation without essential changes in the E0 or slope values. It was used to analyze a real sample and correct results of lead content determination were obtained.

A General Approach to One-Step Fabrication of Single-Piece Nanocomposite Membrane Based Pb2+-selective Electrodes

One-step Electrochemical Sensor Based on an Integrated Probe Toward Sub-Ppt Level Pb2+ Detection by Fast Scan Voltammetry.

Polymer–multiwall Carbon Nantubes Composites for Durable All Solid-Contact H2PO4−-selective Electrodes

Single-piece Solid-Contact Ion-Selective Electrodes with Polymer–carbon Nanotube Composites

Highly selective and sensitive Pb 2+ detection via sulfur-doped graphitic carbon nitride modified by Bi nanospheres

A Planar Disk Electrode Chip Based on MWCNT/CS/Pb2+ Ionophore IV Nanomaterial Membrane for Trace Level Pb2+ Detection

Bismuth Nanoclusters/Porous Carbon Composite: A Facile Ratiometric Electrochemical Sensing Platform for Pb 2+ Detection with High Sensitivity and Selectivity

Bismuth Nanoclusters/Porous Carbon Composite: A Facile Ratiometric Electrochemical Sensing Platform for Pb2+ Detection with High Sensitivity and Selectivity

Exploring the synchronized effect of MWCNT/X-manganate (X-Cu, Zn) nanocomposite for the sensitive and selective electrochemical detection of Hg(II) and Pb(II) in water

Electrochemical sensor array with nanoporous gold nanolayer and ceria@gold corona-nanocomposites enhancer integrated into microfluidic for simultaneous ultrasensitive lead ion detection

Electrochemical sensor based on Bi/Bi2O3 doped porous carbon composite derived from Bi-MOFs for Pb2+ sensitive detection

Highly sensitive and highly selective lead ion electrochemical sensor based on Zn/Cu-BTC-NH 2 bimetallic MOFs with nano-reticulated reinforcing microstructure

Nanoporous Gold-Modified Screen-Printed Electrodes for the Simultaneous Determination of Pb2+ and Cu2+ in Water

Voltammetric Sensing of Pb(II) Using a Glassy Carbon Electrode Modified with Composites Consisting of Co3O4 Nanoparticles, Reduced Graphene Oxide and Chitosan

Selective and Sensitive Electrochemical Determination of Pb 2+ Based on Highly Adsorptive WO X –ethylenediamine Nanowires

Patient‐reported outcomes of multiple myeloma patients treated with panobinostat after ≥2 lines of therapy based on the international phase 3, randomized, double‐blind, placebo‐controlled PANORAMA‐1 trial

Improved Lead Sensing Using a Solid-Contact Ion-Selective Electrode with Polymeric Membrane Modified with Carbon Nanofibers and Ionic Liquid Nanocomposite

Development of a novel sensor based on Bi2O3 and carbonized UIO-66-NH2 nanocomposite for efficient detection of Pb(II) ion in water environment

Disposable Screen-Printed Microchip Based on Nanoparticles Sensitive Membrane for Potentiometric Determination of Lead

Preparation of Electrochemical Sensor for Lead(ii) Based on Molecularly Imprinted Film

In Situ Biosynthesized Polyphosphate Nanoparticles/reduced Graphene Oxide Composite Electrode for Highly Sensitive Detection of Heavy Metal Ions.