Abstract:This paper presents the implementation and verification of a dual-probe measurement system with a novel method and easily integrated chromatic confocal probes, for synchronous evaluation of not only the inner and outer cylindricity but also the thickness distribution of a ring-type cylinder. A pair of measuring probes mounted on a four-axis scanning stage, which is composed of XYZ-slides and a spindle, is utilized to target the two sides of the ring-type cylinder. In the developed system, to reduce the influence of the positioning errors and tilt misalignments of the confocal probes and the cylinder, alignment methods are developed. The outputs of the measuring probes are employed to accurately evaluate the geometric errors of the ring-type cylinder through performing spiral scanning while separating the Z-slide and spindle motion errors of the scanning stage based on a reversal error separation method. To verify the performance of the proposed system and method, the geometric errors of a thin-walled cylinder which has a nominal outer diameter of 50 mm, an inner diameter of 40 mm, and a length of 100 mm are evaluated in experiments. The experimental results are further compared with those by a coordinate measuring machine (CMM), and the high correspondence of the comparison results well confirm the feasibility of the implemented measurement system. Finally, measurement uncertainty analysis is conducted to demonstrate the reliability of the proposed method for the evaluation of the geometric errors of ring-type cylinders. The measurement accuracy is comparable to that of a CMM.

Method for Measurement Uncertainty Evaluation of Cylindricity Error Based on Good Point Set

Implementation Uncertainty Evaluation of Cylindricity Errors Based on Geometrical Product Specification (Gps)

Application of Monte Carlo Method in the Measurement Process Design According to Next Generation of Gps

A Novel Method for Uncertainty Evaluation of Roundness Errors Based on Geometrical Product Specification

Uncertainty Evaluation and Optimization of INS Installation Measurement Using Monte Carlo Method

Application of Quasi-Monte Carlo Method Based on Good Point Set in Tolerance Analysis

Method for Cylindricity Errors Evaluation Using Particle Swarm Optimization Algorithm

Study on the Uncertainty of Straightness Errors Base on New Generation Geometrical Product Specification

Uncertainty Evaluation for a Three Dimensional Rotary Measuring System by Markov Chain Monte Carlo Method

An Iterative Minimum Zone Algorithm for Assessing Cylindricity Deviation

Uncertainty Evaluation Study of CMM Dynamic Measurement Based on Quasi Monte Carlo Method

Implementation and Verification of a Dual-Probe Measurement System for Geometric Form Evaluation of a Ring-Type Cylinder

Geometric Analysis of Measurement Errors in a Surface Metrology Class with Closed-Loop Probes

A study on mutative scale straightness measurement based on uncertainty analysis

Full-scale Measurement of CNC Machine Tools

Volumetric Error Modeling And Analysis For Cnc Machine Tool Based On Multi-Body System

Uncertainty Modeling and Evaluation of CMM Task Oriented Measurement Based on SVCMM

Geometry Simulation and Evaluation of the Surface Topography in Five-Axis Ball-End Milling

Study on dynamic measurement uncertainty evaluation for CMMs

Uncertainty Estimation in Form Error Evaluation of Freeform Surfaces for Precision Metrology

A Novel Method of Efficient Machining Error Compensation Based on Nurbs Surface Control Points Reconstruction