Abstract:Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, Ahead of Print. Blade has the characteristics of high machining quality of complex curved surface. If there is no benchmark before machining, it is impossible to judge whether the blades before machining are qualified. Therefore, it is necessary to analyze the blade measurement data. Due to the large measurement point error and disordered distribution, it is necessary to optimize the blade registration. Therefore, blade model registration and positioning is particularly important in blade shape detection and analysis. First, preregistration is carried out based on the six point optimization selection of the blade. After preregistration, the selection method of registration control point set based on theoretical model and statistical error is proposed, planning the registration datum point set on the blade model. The registration control point set is obtained through the registration operation between the measurement data and the registration reference point set. Finally, based on the stability and reliability of important sampling sensitivity and statistical error, obtain the probability density function of error normal distribution statistics samples and important samples. The selection of statistical control points and the rationality of the objective function were verified. The stability/reliability of the statistical alignment point selection is proved to be feasible. The statistical registration deviation is [0.015,0.026] mm, and the ICP registration deviation is [0.031,0.035] mm. The average deviation of statistics registration is about 0.013 mm smaller than the average deviation of ICP registration. The deviation of statistical sampling points is about 0.0214 mm, and that of traditional sampling points is about 0.0275 mm. The deviation of statistical sampling points is about 0.0061 mm smaller than that of traditional sampling points. It meets the requirements of rapid, high efficiency and high precision measurement for aeroengine blades.

Analysis of Aero-engine Blade Surface Laser Point Cloud 3D Reconstruction Error

Profile Analysis Method Based on Point Cloud Scanning of Blade Profile

Surface Reconstruction for Thin Aero Engine Blade from Disorganized Contact Measured Points

Error Correction Of Laser Scanning System For Reverse Engineering

Blade Profile Extraction and Edge Completion Method Based on Structured Light Measurement Point Cloud

Rapid Method to Measure Turbine Blade Based on Laser Sensor

A New Methodology for Evaluating Profile and Position Errors of Blade Based on Parameter Priority

A Rapid Method To Achieve Aero-Engine Blade Form Detection

Stream Surface Reconstruction of Aero Engine Blade Based on Limited Measured Points.

Fringe Projection Profilometry for Three-Dimensional Measurement of Aerospace Blades

Error analysis and compensation of compound measuring system for blade surface

Optical Measurement and 3-D Reconstruction of Blade Profiles With Attention-Guided Deep Point Cloud Registration Network

Research on blade statistics measurement registration planning technology

An adaptive sampling method for accurate measurement of aeroengine blades

Calibration of Sensor Pose Error in Aero-Engine Blade Measurement

Application of Local-Feature-Based 3-D Point Cloud Stitching Method of Low-Overlap Point Cloud to Aero-Engine Blade Measurement

A sampling method for blade measurement based on statistical analysis of profile deviations

Measuring the Profile of Aircraft Engine Blades Using Spectral Confocal Sensors

Error Analysis And Compensation Of Single-Beam Laser Triangulation Measurement

Weld-seam identification and model reconstruction of remanufacturing blade based on three-dimensional vision

Profile Error Calculation for Gas Turbine Blade Based on Subdivision Approach Algorithm and Particle Swarm Optimization