Abstract:Laser peen forming (LPF) is a purely mechanical forming method achieved through the use of laser energy to form complex shapes or to modify curvatures. It is flexible and independent of tool inaccuracies that result from wear and deflection. Its nonthermal process makes it possible to form without material degradation or even improve them by inducing compressive stress over the target surface. In the present study, a fully three-dimensional numerical model is developed to simulate the forming process of laser peen forming. The simulation procedure is composed of several steps mainly including the shock pressure prediction, the modal analysis, and the forming process calculation. System critical damping is introduced to prevent unnecessary long post-shock residual oscillations and to greatly decrease the solution time for simulation. The bending profiles and angles with different thicknesses are experimentally measured at different scanning lines and scanning velocities to understand the process and validate the numerical model. The calculated bending profiles and angles agree well with the trend of the measured results. But it is found that simulations with the Johnson-Cook model are more consistent, matching the experimental results for the thick sheet metal with a convex bending, while the elastic-perfectly-plastic model produces a better agreement even though with underestimated values for the thinner sheet metal with a concave bending. The reason for this phenomenon is discussed, combining the effects of strain rate and feature size. Both the simulation and the experiments show that a continuous decrease in bending angle from concave to convex is observed with increasing specimen thickness in general. Large bending distortion is easier to induce by generating a concave curvature with LPF, and the angle of bending distortion depends on the number of laser shocks. [DOI: 10.1115/1.4002585]

Process Modelling in Laser Forming of Doubly-Curved Sheets from Cylinder Shapes

Study on Processing Strategy of Complicated Doubly Curved Surface in Laser Forming

Laser Forming of Doubly Curved Plates Using Minimum Energy Principle and Comprehensive Strain Control

Processing Strategy for Laser Forming of Complicated Singly Curved Shapes

Study on processing strategy of singly curved surface based on plastic strain field in laser forming

Modelling of laser forming – An review

Heating Position Planning in Laser Forming of Single Curved Shapes Based on Probability Convergence

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Dynamic Analysis on Laser Forming of Square Metal Sheet to Spherical Dome

Laser Forming of Plates Using Two Sequent Scans of Different Intervals

A Finite Element Model Using Multi-Layered Shell Element in Laser Forming

Process Planning for Laser Peen Forming of Complex Geometry: an Analytical-Based Inverse Study

An Analytical Model for Estimating Deformation in Laser Forming

Mixed-dimensional coupling modeling for laser forming process

A Study on Bending Direction of Sheet Metal in Laser Forming

Three-dimensional numerical simulation and experimental study of sheet metal bending by laser peen forming

Simulation and experimental research on spherical dome by 3D laser forming of square sheet

Varying Velocity Scan in Laser Forming of Plates

FEM Realization of Laser Curve Bending Process

Deformation Behaviors of Laser Forming of Ring Sheet Metals

Analysis on Bending Angle of Laser Forming