Abstract:Wireless Power Transfer (WPT) and wireless data communication are both important problems of research with various applications, especially in medicine. However, these two problems are usually studied separately. In this work, we present a joint study of both problems. Most medical electronic devices, such as smart implants, must have both a power supply to allow continuous operation and a communication link to pass information. Traditionally, separate wireless channels for power transfer and communication are utilized, which complicate the system structure, increase power consumption and make device miniaturization difficult. A more effective approach is to use a single wireless link with both functions of delivering power and passing information. We present a design of such a wireless link in which power and data travel in opposite directions. In order to aggressively miniaturize the implant and reduce power consumption, we eliminate the traditional multi-bit Analog-to-Digital Converter (ADC), digital memory and data transmission circuits all together. Instead, we use a pulse stream, which is obtained from the original biological signal, by a sigma-delta converter and an edge detector, to alter the load properties of the WPT channel. The resulting WPT signal is synchronized with the load changes therefore requiring no memory elements to record inter-pulse intervals. We take advantage of the high sensitivity of the resonant WPT to the load change, and the system dynamic response is used to transfer each pulse. The transient time of the WPT system is analyzed using the coupling mode theory (CMT). Our experimental results show that the memoryless approach works well for both power delivery and data transmission, providing a new wireless platform for the design of future miniaturized medical implants.

A Power and Data Decoupled Transmission Method for Wireless Power Transfer Systems via a Shared Inductive Link

Study of Data and Power Transmission Based on Frequency-Shift Modulation in Wireless Charging

A New Simultaneous Wireless Power and Information Transfer System with Integrated Signal Magnetic Coupler.

A study of the self-coupling magnetic resonance coupled wireless power transfer

Wireless Power and Data Transfer Via a Common Inductive Link Using Frequency Division Multiplexing

Design and Optimization of a Modular Wireless Power System Based on Multiple Transmitters and Multiple Receivers Architecture

A New Controller for Bi-directional Wireless Power Transfer Systems

Adaptive Wireless Power Transfer System With Relay Transmission and Communication

A shared-link type wireless power and data simultaneous transfer system based on a series–parallel resonant network

An Efficient Power and Data Synchronous Transfer Method for Wireless Power Transfer System Using Double-D Coupling Coil

A FDM-based Simultaneous Wireless Power and Data Transfer (SWPDT) System Functioning with High-rate Full-duplex Communication

Wireless Power and Information Dual Transfer System Via Magnetically Coupled Resonators

DiTTO: A Distance Adaptive Over 100-mW Wireless Power Transfer System With 1.695-Mb/s Uplink Telemetry and a Shared Inductor Two-Output Regulating Rectification

Coil-Splitting Based Dynamic WPT with Multiple Transmitter Coils in Parallel

Simultaneous Wireless Power and Information Transmission Based on Harmonic Characteristic of Soft-Switching Inverter

Simultaneous Wireless Power Transfer and Data Communication Using Synchronous Pulse-Controlled Load Modulation

Adaptive Bidirectional Inductive Power and Data Transmission System

A Simultaneous Wireless Power and Uplink Data Transfer System with Ultra-Low Crosstalk Between the Power and Data Link.

Position-independent self-adaptive wireless power transfer: topology, modeling, and design

Orthogonal-Frequency Simultaneous Wireless Power and Data Transfer for High-Power Wireless EV Charging

A Dual-Frequency Three-Dimensional WPT System with Directional Power Transfer Capability at Two Separately Regulated Outputs