Abstract:<p>In this paper, based on the traditional low-frequency self-excited oscillation pulsed jet device, a self-excited aspiration pulsed jet device is designed. For the structural parameters, including the aspiration capacity, impact characteristics, and pulse generation mechanism, the jet impingement is analyzed experimentally under the aspiration and non-aspiration conditions. It was found that, compared to the non-aspiration condition, the maximum aspiration capacity, the increase of instantaneous impact force, and the obvious pulse period, which is between 1–2 s, can be obtained under appropriate structural device parameters. The db10 orthogonal wavelet and the empirical mode decomposition methods can decompose instantaneous impact force into time-varying and fluctuating impact forces. However, under different confining pressures, each method has its own advantages in extracting the time-varying impact force. In addition, after aspiration, the confining pressure and target distance have little effect on the pulse frequency of the time-varying impact force, while higher confining pressure and larger target distance result in smaller pulse amplitude. Under different confining pressures and target distances, after aspiration, the time-average impact force at and near the target center increases, while far away from the target center it decreases. Moreover, after aspiration, the fluctuation amplitude and intensity of the fluctuating impact force increase, and the confining pressure has little effect on the pulse frequency. However, higher confining pressure results in smaller fluctuation amplitude, intensity, and energy spectral density. After aspiration, subsonic and supersonic water flows are formed inside the device. In addition, it was found that there is a relationship between the aspiration capacity, the time-variation pressure of the collision body measuring point, and the impact force. Based on this relation, the pulse generation mechanism of the device is revealed.</p>

Experimental Research of the Pulse II Ignition Impact Process of Double Pulse Motor

Experimental Investigation of Two-Phase Flow and Heat Transfer Performance in a Cooling Gallery under Forced Oscillation

Twin-Peak Heat Release Phenomenon Inside a Heavy-Duty Diesel Engine Retrofitted to Natural-Gas Spark Ignition

Experimental Results of the Internal Process of A Double Inlet Pulse Tube Refrigerator

Experimental Research of High-Pressure Methane Pulse Jet and Premixed Ignition Combustion Performance of a Direct Injection Injector

Research on the Design and Bidirectional Work Process of Metal Diaphragms in Small Double-Pulse Solid Rocket Motors

The effect of operating frequency and ignition energy on JP-10/PO/aluminum powder multiphase-pulse-detonation-engine

2.5 kN pump-pressure pintle engine ignition experiment in different loading cases

Simulation and Experimental Research on a Mixed Pulse Converter Turbocharging System

Numerical Investigation of the Pressure Gain Obtained by the Double-Stage JP-10/air Detonation Wave

Experimental Investigation on Performance and Heat Release Analysis of a Pilot Ignited Direct Injection Natural Gas Engine

An Investigation into the Design and Performance of Pre-combustion Chamber Jet Igniter

Design of Pulse Generator Used in Transient Performance Experiment of Turbocharger Turbine

Experimental investigation on pulse operation characteristics of rotating detonation rocket engine

Shock train response to pulse backpressure forcing

Influence of Pressure Pulsation on the Performance of Compression System and Turbocharged Engine

Experimental Investigation on Thrust Augmentation of Pulsed Detonation Engine(PDE)

Analysis of pulse combustion processes and thermodynamic cycles in pulse combustors

Experimental Investigation on Ignition of Hyperburner Based on Gliding Arc Plasma Igniter Driven by Pressure Difference

Numerical Study of the Effect of MHD Accelerator Technology on the Thrust Augmentation in Pulse Detonation Engine

Investigation of the impact characteristics and pulse mechanism of a self-excited aspiration pulsed jet device