Abstract:Recently, an emerging category of thermal plastic energetic binder: nitrate glycerol ether cellulose (NGEC) exhibits promising application in propellants with extraordinary mechanical performance, and can be considered for using in military system instead (or partial) of traditional nitrocellulose (NC). In this paper, the electrostatic spraying technology is performed to synthesis a novel kind of nanocomposites energetic materials (nEMs) (hexahydro-1,3,5-trinitro-1,3,5-triazine) RDX@NGEC by adjusting the mass ratio of NGEC:RDX (0:5 ∼ 2.5:2.5). The results demonstrate that the NGEC patches with content of 30% were coated relatively uniformly on the surface of RDX crystal, and an ideal spherical structure, with dramatically reduced particle size (100 ∼ 800 nm) was obtained. Most importantly, the thermal decomposition properties are investigated systematically by traditional DSC (differential scanning calorimeter) analysis, DSC-TG-IR (DSC-thermogravimetric analysis-fourier-transform infrared spectroscopy) combining technology, where the kinetic parameters of thermal decomposition reaction are also calculated by two traditional methods: the Kissinger and Ozawa methods. It reveals that the process of the decomposition is mainly controlled by RDX when content of NGEC is low (10%∼20%), and the decomposition peak of NGEC is gradually appearing with the increasing content of NGEC (30%∼50%). Furthermore, the impact and friction sensitivities are tested and have been reduced about 1 ∼ 3 times. The mechanism of the sensitivity reduction, coating process and decomposition are also discussed detailly. Hence, this preparation and properties strategy of novel energetic RDX@NGEC nanocomposites may provide foundational theory research and exhibits application potential in propellants and explosives.

Groove Charge of a Rigid Multi-Point Initiation Explosive Network

Design of Multi-point Synchronous Initiation Circuit for Shaped Charge

Towards the Low-Sensitive and High-Energetic Co-Crystal Explosive CL-20/TNT: from Intermolecular Interactions to Structures and Properties

Structure optimization of linear shaped charge based on different explosives

Study on Dynamic Impact and Ignition Response Behavior of GAP/PET/RDX Based Propellant

Research On The Rule Of Multi-Point Initiation Replacing Annulus Initiation Under Different Charge Caliber

Variable air blast fireball of HMX/Al with tailored gradient structures

Crystal phase control and ignition properties of HNS/CL-20 composite microspheres prepared by microfluidics combined with emulsification techniques

Theoretical investigation of potential energetic material CL-20/TNBP co-crystal explosive based on molecular dynamics method

Study on mechanical improvement of CL‐20 energetic co‐crystals based PBX by surface modification

Shock-to-detonation transition behavior of functionally graded energetic materials

Electrostatic spraying synthesis of energetic RDX@NGEC nanocomposites

High Energy Explosive with Low Sensitivity: A New Energetic Cocrystal Based on CL-20 and BMDNP

Molecular dynamics simulation of CL20/DNDAP cocrystal-based PBXs

The effect of annular multi-point initiation on the formation and penetration of an explosively formed penetrator

Evolution of HTPB/RDX/Al/DOA mixed explosives with 90% solid loading in resonance acoustic mixing process

Theoretical investigations on CL‐20/TNBA co-crystal explosive via density functional method and molecular dynamics method

High-quality and Homogeneous HMX-based Aluminized Explosives Using Droplet Microfluidic Technology

Devising a composite membrane with a creeper sucker structure to enhance the interfacial performance and desensitization of CL-20

Interaction, Insensitivity and Thermal Conductivity of CL-20/TNT-Based Polymer-Bonded Explosives through Molecular Dynamics Simulation